USB2504/USB2504A

DS000002250A-page 30

 2007 - 2016 Microchip Technology Inc.

6.0

BACKWARD COMPATIBILITY TO THE USB20H04

The USB2504/USB2504A is pin compatible to the USB20H04, but is not designed to be a direct drop-in replacement.

Many existing USB20H04 designs may accommodate a USB2504/USB2504A in place of the USB20H04, as long as

specific Bill-Of-Material (BOM) modifications and population option changes are implemented. Since each design is

unique, every customer considering a change from a USB20H04 to a USB2504/USB2504A should contact Microchip

Applications Engineering for assistance.

6.1

Internal 1.8V regulator

The USB2504/USB2504A has two internal 1.8V regulators that are enabled by default (ATEST pin contains an internal

pull-up, and was specified as a No-Connect in the USB20H04 Data Sheet). Each regulator requires a separate 4.7uF

Low ESR capacitor to ground. The USB20H04 designs that directly connect the Digital and Analog 1.8V pins together

will not support a USB2504/USB2504A (unless the internal regulators are disabled).

6.2

Configuration by Internal Defaults

The internal default settings that are loaded when this option is selected are very similar (but not identical) to those that

were loaded in the USB20H04. The CFG_SEL[2:0] pins will properly select this method if the existing USB20H04 design

was set-up to load the configuration via internal defaults.

The USB2504/USB2504A has pin strapping options that enable modification of the internal default load without requir-

ing an EEPROM. The CFG_SEL2 pin (pin 59) on the USB2504/USB2504A was a VSS pin on the USB20H04 so this

functionality will be disabled when a USB2504/USB2504A is placed into a USB20H04 design.

6.3

Configuration by SMBus

The CFG_SEL[2:0] pins will properly select this method if the existing USB20H04 design was set-up to load the config-

uration via SMBus. The USB2504/USB2504A has a few additional registers, and has also moved some of the configu-

ration bits so the actual SMBus code load itself will need to be modified. If a USB20H04 SMBus load is programmed

into a USB2504/USB2504A, the results are unpredictable.

6.4

PRTPWR_POL

The USB2504/USB2504A has a new strapping option that enables the port power control active state to be either active-

high or active-low. The USB20H04 only provided active-low port power control. The PRTPWR_POL pin on the

USB2504/USB2504A is pin 23, which was a VSS pin on the USB20H04, so by default, a USB20H04 design will select

active-low port port control.