2

N.FL Series

■Specifications

Nominal characteristic impedance

Frequency range

50 ohms

DC to 6 GHz

Operating temperature range

Storage temperature range

-40°C to +90°C

(90% RH max.)

-30°C to +70°C

(90% RH max.)

Ratings

Note1: N.FL Cable assembly (plug) is measured with SMA conversion

adapters mated with N.FL plugs at both ends of a 100cm coaxial

cable harness

Note2: N.FL receptacle, which is mounted on a 50 ohms glass epoxy

board, is measured with a SMA conversion adapter.

Network Analyzer

Test Set

Test Port

Termination

D.U.T

Test Port Cable

■Materials / Finishes

●Plugs-Right Angle

Part

Material

Finish

Shell

Phosphor bronze

Silver plated

Female center contact

Phosphor bronze

Gold plated

Insulator

PBT

Color: Black, UL94V-0

Color: Gray, UL94HB(HF type)

●Receptacle

Part

Material

Finish

Shell

Phosphor bronze

Silver plated

Male center contact

Brass

Gold plated

Insulator

LCP

Color: Black, UL94V-0

Item

Specification

Conditions

1. Contact resistance

Center

contact: 25 m ohms max.

Outer

contact: 25 m ohms max.

10 mA max.

2. Insulation resistance

500 M ohms min.

100V DC

3. Withstanding voltage

No flashover or insulation breakdown

200V AC / 1 minute

4. V.S.W.R.(Note)

1.3max.

DC to 6GHz

5. Durability

Contact resistance

Center

contact: 30 m ohms max.

Outer

contact: 30 m ohms max.

No damage, cracks, or parts dislocation

20 cycles

6. Vibration

No electrical discontinuity of 1 µs or longer

No damage, cracks, or parts dislocation

Frequency: 10 to 100 Hz, single amplitude of 1.5 mm

5 cycles

7. Shock

No electrical discontinuity of 1 µs or longer

No damage, cracks, or parts dislocation

Waveform: sine half-wave, 3 cycles in each of the 3 axis

8. Humidity

Insulation resistance: 100 M ohms min. (high humidity)

Insulation resistance: 500 M ohms min. (dry)

No damage, cracks, or parts dislocation

96 hours at +40°C, and humidity of 95%

9. Temperature cycle

No damage, cracks, or parts dislocation

Temperature:-40°C

/+5°C to +35°C/+90°C/+5°C to +35°C

Time: 30 min.

/ 5 min. max. / 30 min. / 5 min. max.

5 cycles

10. Salt spray test

No excessive corrosion

5% salt water solution, 48 hours

Note: Information contained in this catalog represents general requirements for this Series. Contact us for the drawings and

specifications for a specific part number shown.

* V.S.W.R. Measurement System

Measured as shown on the block diagram below.