PISA11.CLASS2

PISA11-Series

All terminals are easy to access when mounted on the panel.

Input, outputs and signal terminals are separated from each other to help in error-free wiring.

Input and Output

Signals

Type

screw terminals

plug connector

Solid wire

Stranded wire

AWG (American Wire Gauge)

24-10 AWG

24-16 AWG

Wire stripping length

7mm / 0.28inch

6mm / 0.24inch

Screwdriver

3.5mm slotted or

Pozidrive No 2

2.5mm slotted

Recommended tightening torque

0.8Nm, 7lbs.in

0.35Nm, 3lbs.in

Instructions:

a) Use NEC Class 2 rated wires for the output

b) Use appropriate copper cables that are designed for minimum operating temperatures of:

60°C for ambient up to 45°C and minimum

75°C for ambient up to 60°C and minimum

90°C for ambient up to 70°C.

c) Follow national installation codes and installation regulations!

d) Ensure that all strands of a stranded wire enter the terminal connection!

e) Screws of unused terminal compartments should be securely tightened.

f) Ferrules are allowed.

May 2014 / Rev. 1.7 DS-PISA11.CLASS2 - data sheet -

All parameters are specified at 24Vdc input, 25°C ambient temperature and a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278-0

Germany

13/19