VIPER0P datasheet(5/36 Pages) STMICROELECTRONICS

5 / 36 page

VIPer0P

Pin setting

DocID028423 Rev 2

5/36

Pin setting

Figure 2: Connection diagram

The PCB copper area for heat dissipation has to be provided under the DRAIN

pins.

Table 1: Pin description

SO16N

Name

Function

PGND

Power ground and MOSFET source. The pulsed current flowing through the

Power MOSFET must be closed on this pin. The pin must be connected to

the same ground plan of SGND with the shortest track.

EAGND

Error amplifier ground reference. In case of non-isolated flyback converter

with negative output voltage, this pin can be connected directly to the

negative rail. Otherwise, in case of positive output voltage, the pin must be

shorted to SGND.

VCC

Controller supply. An external storage capacitor has to be connected across

this pin and SGND. The pin, internally connected to the high-voltage current

source, provides the VCC capacitor charging current at startup and, if self-

supply mode is selected, also during steady-state operation. A small bypass

capacitor (0.1 μF typ.) in parallel, placed as close as possible to the IC, is also

recommended, for noise filtering purpose.

SGND

Signal ground. All of the groundings of bias components must be tied to a

trace going to this pin and kept separate from the pulsed current return.

Direct feedback. It is the inverting input of the internal transconductance E/A,

which is internally referenced to 1.2 V with respect to EAGND. In case of non-

isolated converter, the output voltage information is directly fed into the pin

through a voltage divider. In case of primary regulation, the FB voltage divider

is connected to the VCC. The E/A is disabled soldering FB to EAGND.

COMP

Compensation. It is the output of the internal E/A. A compensation network

is placed between this pin and SGND to achieve stability and good dynamic

performance of the control loop. In case of secondary feedback, the internal

E/A must be disabled and the COMP directly driven by the optocoupler to

control the DRAIN peak current setpoint.

PGND

DRAIN

SGND

COMP

EAGND

OFF

DRAIN

N.C.

VCC

VIPer0P

GIPD210420151108MT

VIPER0P 数据表(PDF) 5 Page - STMicroelectronics

VIPER0P 数据表(HTML) 5 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

数据表下载