5

TPA3136D2, TPA3136AD2

www.ti.com

SLOS938D – MAY 2016 – REVISED MARCH 2017

Product Folder Links: TPA3136D2 TPA3136AD2

Submit Documentation Feedback

Copyright © 2016–2017, Texas Instruments Incorporated

(1)

Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings

only, which do not imply functional operation of the device at these or any other conditions beyond those indicated under Recommended

Operating Conditions. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

(2)

The voltage slew rate of these pins must be restricted to no more than 10 V/ms. For higher slew rates, use a 100 kΩ resister in series

with the pins.

(3)

The TPA3136D2 incorporates an exposed thermal pad on the underside of the chip. This acts as a heatsink, and it must be connected

to a thermally dissipating plane for proper power dissipation. Failure to do so may result in the device going into thermal protection

shutdown. See TI Technical Briefs SLMA002 for more information about using the TSSOP thermal pad.

7 Specifications

7.1 Absolute Maximum Ratings

over operating free-air temperature range (unless otherwise noted)

(1)

MIN

MAX

UNIT

Supply voltage

AVCC to GND, PVCC to GND

–0.3

16

V

Input current

To any pin except supply pins

10

mA

Voltage

–0.3

AVCC + 0.3

V

10

V/ms

Voltage

RINN, RINP, LINN, LINP

–0.3

6.3

V

BTL, PVCC > 12 V

4.8

Ω

BTL, PVCC

≤ 12 V

3.2

PBTL, PVCC > 12 V

2.5

PBTL, PVCC

≤ 12 V

1.8

Continuous total power dissipation

See the Thermal Information Table

(3)

–40

85

°C

Temperature range

–65

150

°C

–65

150

°C

(1)

JEDEC document JEP155 states that 500-V HBM allows safe manufacturing with a standard ESD control process.

(2)

JEDEC document JEP157 states that 250-V CDM allows safe manufacturing with a standard ESD control process.

7.2 ESD Ratings

VALUE

UNIT

±1000

V

±250

(1)

The TPA3136D2/TPA3136AD2 incorporates an exposed thermal pad on the underside of the chip. This acts as a heatsink, and it must

be connected to a thermally dissipating plane for proper power dissipation. Failure to do so may result in the device going into thermal

protection shutdown. See TI Technical Briefs SLMA002 for more information about using the TSSOP thermal pad.

7.3 Recommended Operating Conditions

over operating free-air temperature range (unless otherwise noted)

PARAMETER

TEST CONDITIONS

MIN MAX

UNIT

Supply voltage

PVCC, AVCC

TPA3136

4.5

14.4

V

TPA3136A

8

14.4

High-level input voltage

SD, PBTL

2

AVC

C

V

Low-level input voltage

SD, PBTL

0.8

V

Low-level output voltage

0.8

V

High-level input current

50

µA

Low-level input current

5

µA

Operating free-air

–40

85

°C

Operating junction

-40

150

°C