AD7983BCPZ-R2 datasheet(24/25 Pages) AD

24 / 25 page

Data Sheet

AD7983

Rev. B | Page 23 of 24

APPLICATION HINTS

LAYOUT

The printed circuit board (PCB) that houses the AD7983

should be designed so that the analog and digital sections are

separated and confined to certain areas of the board. The pinout of

the AD7983, with all its analog signals on the left side and all its

digital signals on the right side, eases this task.

Avoid running digital lines under the device because these couple

noise onto the die, unless a ground plane under the AD7983 is

used as a shield. Fast switching signals, such as CNV or clocks,

should never run near analog signal paths. Crossover of digital

and analog signals should be avoided.

At least one ground plane should be used. It can be common or

split between the digital and analog section. In the latter case,

the planes should be joined underneath the AD7983.

The AD7983 voltage reference input REF has a dynamic input

impedance and should be decoupled with minimal parasitic

inductances. This is done by placing the reference decoupling

ceramic capacitor close to, ideally right up against, the REF and

GND pins and connecting them with wide, low impedance traces.

Finally, the AD7983 power supplies, VDD and VIO, should be

decoupled with ceramic capacitors, typically 100 nF, placed

close to the AD7983 and connected using short and wide traces

to provide low impedance paths and to reduce the effect of

glitches on the power supply lines.

An example of a layout following these rules is shown in

Figure 38 and Figure 39.

EVALUATING THE PERFORMANCE OF THE AD7983

Other recommended layouts for the AD7983 are outlined

in the documentation of the evaluation board for the AD7983

(EVAL-AD7983SDZ). The evaluation board package includes

a fully assembled and tested evaluation board, documentation,

and software for controlling the board from a PC via the

EVAL-SDP-CB1Z.

AD7983

Figure 38. Example Layout of the AD7983 (Top Layer)

Figure 39. Example Layout of the AD7983 (Bottom Layer)

AD7983BCPZ-R2 数据表(PDF) 24 Page - Analog Devices

AD7983BCPZ-R2 数据表(HTML) 24 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

数据表下载