Data Sheet

AD8141/AD8142

Rev. B | Page 19 of 24

SINGLE 5 V SUPPLY APPLICATION INFORMATION

The AD8141 and AD8142 require a nominal voltage of 5 V

local system ground must be greater than or equal to 2.5 V and

less than or equal to 5 V. These requirements can be met by a

single +5 V supply, or split supplies such as ±2.5 V, +3 V/−2 V,

and so on. Operating the AD8141 and AD8142 with ±2.5 V

supplies provides considerable power savings compared with

other drivers operating at ±5 V supplies, without any disadvantages

with regard to input and output ranges in most cases.

The receivers used with the AD8141 and AD8142, such as the

AD8145, AD8143, AD8123, and AD8128, generally operate

with split supplies, ranging from ±5 V to ±12 V. The split supply

arrangement results in a receiver input common-mode range

that is centered at 0 V relative to the local ground reference and

ranges to within a volt or two from each rail. Ground potential

differences normally exist between the driver end and the receiver

end, and these differences cause the relative common-mode

voltages between the driver and receiver to shift. See Figure 43

for an example.

down by 2 V relative to the driver ground, and the common-

mode level on the cable stays constant. It can be seen from this

example that the most margin to absorb ground shifts exists

when the center of the receiver input common-mode voltage

range relative to its ground is the same as the output common-

mode voltage of the driver with respect to its ground.

Most receivers operate with their input common-mode ranges

centered at 0 V; therefore, the best case for the driver is to set its

output common-mode voltage to 0 V. This is not possible for

the AD8141 or AD8142 on a single 5 V supply, but it can be

accomplished using split supplies. If a single 5 V supply is required,

the rail-to-rail output allows the AD8141 output common-mode

voltage to be set to less than 1 V to be as close as possible to the

ideal setting of 0 V. Whereas the AD8141 has uncommitted

that fixes the nominal output common-mode voltage at 1.5 V

above the negative rail. Each part has a resistive divider on the

to 1.5 V above the negative rail when no external voltage is applied.

30% of the voltage across the supplies. In the single 5 V supply

case, the Thevenin load voltage is 30% of 5 V above 0 V, or 1.5 V.

+

–

100Ω

49.9Ω

DRIVER

100Ω

UTP

49.9Ω

+

–

+

–

+ –

+

–

AD8141/AD8142

Figure 43. End-to-End Common-Mode Shifts due to Ground Shifts