Uniform Sector

Standard and Dual Serial Flash

GD25WD10C/05C

16

7.8. Dual Output Fast Read (3BH)

The Dual Output Fast Read command is followed by 3-byte address (A23-A0) and a dummy byte, and each bit being

latched in on the rising edge of SCLK, then the memory contents are shifted out 2-bit per clock cycle from SI and SO.

The command sequence is shown in followed Figure7. The first byte addressed can be at any location. The address is

automatically incremented to the next higher address after each byte of data is shifted out.

Figure7. Dual Output Fast Read Sequence Diagram

7.9. Page Program (PP) (02H)

The Page Program (PP) command is for programming the memory. A Write Enable (WREN) command must

previously have been executed to set the Write Enable Latch (WEL) bit before sending the Page Program command.

The Page Program (PP) command is entered by driving CS# Low, followed by the command code, three address

bytes and at least one data byte on SI.

If the 8 least significant address bits (A7-A0) are not all zero, all transmitted data that goes beyond the end of the

current page are programmed from the start address of the same page (from the address whose 8 least significant bits (A7-

A0) are all zero). CS# must be driven low for the entire duration of the sequence.

The Page Program command sequence: CS# goes low  sending Page Program command  3-byte address on SI

 at least 1 byte data on SI  CS# goes high. The command sequence is shown in Figure8.

If more than 256 bytes are sent to the device, previously latched data are discarded and the last 256 data bytes are

guaranteed to be programmed correctly within the same page. If less than 256 data bytes are sent to device, they are

correctly programmed at the requested addresses without having any effects on the other bytes of the same page. CS#

must be driven high after the eighth bit of the last data byte has been latched in; otherwise the Page Program (PP) command

is not executed.

Program cycle is in progress, the Status Register may be read to check the value of the Write In Progress (WIP) bit. The

Write In Progress (WIP) bit is 1 during the self-timed Page Program cycle, and is 0 when it is completed. At some unspecified

time before the cycle is completed, the Write Enable Latch (WEL) bit is reset.

A Page Program (PP) command is not executed when it is applied to a page protected by the Block Protect (BP2,

BP1, BP0).

Command

0

1

2

3

4

5

6

7

3BH

CS#

SCLK

SI

SO

High-Z

8

9 10

28 29 30 31

3

2

1

0

23 22 21

24-bit address

MSB

34 35 36 37

33

5

3

1

7

5

3

1

38 39

Data Out1

32

42 43 44 45

41

46 47

40

7

Data Out2

CS#

SCLK

SI

SO

MSB

Dummy Clocks

4

2

0

6

4

2

0

6

6

7