IS25LP032D-RLLA3 datasheet(34/118 Pages) ISSI

34 / 118 page

IS25LP032D

IS25WP032D

Integrated Silicon Solution, Inc.- www.issi.com

Rev. A12

08/04/2020

8.1 NORMAL READ OPERATION (NORD, 03h)

The NORMAL READ (NORD) instruction is used to read memory contents at a maximum frequency of 50MHz.

The NORD instruction code is transmitted via the SI line, followed by three address bytes (A23 - A0) of the first

memory location to be read. A total of 24 address bits are shifted in, but only AVMSB (Valid Most Significant Bit) - A0

are decoded. The remaining bits (A23

– AVMSB+1) are ignored. The first byte addressed can be at any memory

location. Upon completion, any data on the SI will be ignored. Refer to Table 8.2 for the related Address Key.

The first byte data (D7 - D0) is shifted out on the SO line, MSB first. A single byte of data, or up to the whole memory

array, can be read out in one NORMAL READ instruction. The address is automatically incremented by one after

each byte of data is shifted out. The read operation can be terminated at any time by driving CE# high (VIH) after

the data comes out. When the highest address of the device is reached, the address counter will roll over to the

000000h address, allowing the entire memory to be read in one continuous READ instruction.

If the NORMAL READ instruction is issued while an Erase, Program or Write operation is in process (WIP=1) the

instruction is ignored and will not have any effects on the current operation.

Table 8.2 Address Key

Valid Address

32Mb

AVMSB

–A0

A21-A0 (A23-A22=X)

Note:

X=Don’t Care

IS25LP032D-RLLA3 数据表(PDF) 34 Page - Integrated Silicon Solution, Inc