H8SLASH3002 datasheet(80/700 Pages) RENESAS

80 / 700 page

Section 4 Exception Handling

4.1 Overview

4.1.1 Exception Handling Types and Priority

As table 4-1 indicates, exception handling may be caused by a reset, trap instruction, or interrupt.

Exception handling is prioritized as shown in table 4-1. If two or more exceptions occur

simultaneously, they are accepted and processed in priority order. Trap instruction exceptions are

accepted at all times in the program execution state.

Table 4-1 Exception Types and Priority

Priority Exception Type

Start of Exception Handling

High

Reset

Starts immediately after a low-to-high transition at the

RES pin

Interrupt

Interrupt requests are handled when execution of the current

instruction or handling of the current exception is completed

Low

Trap instruction (TRAPA) Started by execution of a trap instruction (TRAPA)

4.1.2 Exception Handling Operation

Exceptions originate from various sources. Trap instructions and interrupts are handled as follows.

The program counter (PC) and condition code register (CCR) are pushed onto the stack.

The CCR interrupt mask bit is set to 1.

A vector address corresponding to the exception source is generated, and program execution

starts from that address.

For a reset exception, steps 2 and 3 above are carried out.

H8/3002 数据表(PDF) 80 Page - Renesas Technology Corp