| 数据搜索系统,热门电子元器件搜索 |
|
AS4LC2M8S1 数据表(PDF) 3 Page - Alliance Semiconductor Corporation |
|
|
|||||||||||||||||||||||||||||
AS4LC2M8S1 数据表(HTML) 3 Page - Alliance Semiconductor Corporation |
|
3 / 28 page ![]() AS4LC2M8S1 AS4LC1M16S1 7/5/00 ALLIANCE SEMICONDUCTOR 3 Pin descriptions Pin Name Description CLK System clock All operations synchronized to rising edge of CLK. CKE Clock enable Controls CLK input. If CKE is high, the next CLK rising edge is valid. If CKE is low, the internal clock is suspended from the next clock cycle and the burst address and output states are frozen. If both banks are idle and CKE goes low, the SDRAM will enter power down mode from the next clock cycle. When in power down mode and CKE is low, no input commands will be acknowledged. To exit power down mode, raise CKE high before the rising edge of CLK. CS Chip select Enables or disables device operation by masking or enabling all inputs except CLK, CKE, UDQM/LDQM (×16), DQM (×8). A0~A10 Address Row and column addresses are multiplexed. Row address: A0~A10. Column address (2M × 8): A0~A8. Column address (1M × 16): A0~A7. A11 Bank select Memory cell array is organized in 2 banks. A11 selects which internal bank will be active. A11 is latched during bank activate, read, write, mode register set, and precharge operations. Asserting A11 low selects Bank A; A11 high selects Bank B. RAS CAS WE Row address strobe Column address strobe Write enable Command inputs. RAS, CAS, and WE, along with CS, define the command being entered. ×8: DQM ×16: UDQM, LDQM Output disable/ write mask Controls I/O buffers. When DQM is high, output buffers are disabled during a read operation and input data is masked during a write operation. DQM latency is 2 clocks for Read and 0 clocks for Write. For ×16, LDQM controls the lower byte (DQ0 – 7) and UDQM controls the upper byte (DQ8 – 15). UDQM and LDQM are considered to be in the same state when referred to jointly as DQM. DQ0~DQ15 Data input/output Data inputs/outputs are multiplexed. VCC/VSS Power supply/ground Power and ground for core logic and input buffers. VCCQ/VSSQ Data output power/ground Power and ground for data output buffers. |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |