9727 datasheet(4/26 Pages) 3M

4 / 26 page

General Information

READ INSTRUCTIONS THOROUGHLY BEFORE OPERATING OR PERFORMING ANY

MAINTENANCE ON 3M™ SCOTCH-WELD™ HOT MELT APPLICATOR PG II LT.

The 3M™ Scotch-Weld™ Hot Melt Applicator PG II

LT is designed to be a simple, reliable tool for

dispensing 3M™ Scotch-Weld™ Hot Melt LM

Adhesive Sticks.

Important

Use 3M Scotch-Weld Hot Melt LM Adhesives only.

Use of other adhesives may damage the applicator or

result in hazardous conditions.

It is self-contained and hand held, designed for multi-

station or intermittent manual adhesive application.

The 3M Scotch-Weld Hot Melt Applicator PG II LT

uses electric heat to melt the adhesive, and air

pressure to deliver the adhesive. Adhesive

temperature is automatically maintained by a fixed

thermostat on the heat block. The system is further

protected by a thermal cutout (TCO), which acts as a

thermal fuse.

Please take time to properly fill out and return

your 3M Scotch-Weld Hot Melt Applicator PG II

LT Warranty Card.

When trigger (1) is pulled, the variable regulator (2)

allows air pressure into rear of the Speedloader stick

feed (3). Air pushes the piston (4), which advances

adhesive stick through applicator. As adhesive

advances, it passes through hard plastic insulating

sleeve (5) which acts as thermal barrier to keep

molten adhesive and heat in forward portion of the

applicator. The rest of the applicator stays cool.

As adhesive advances into the heat block, it is melted

and liquefied. With pressure from the solid adhesive

sticks and the piston, the liquid adhesive is forced out

of the applicator through the nozzle tip (6). When the

trigger is released, air pressure is released from the

rear of the loading chamber. Pressure on the molten

adhesive in the front of the applicator is then also

relieved. Spring tension in the nozzle valve retracts

the valve, neatly cutting off the adhesive flow.

The delivery rate of molten adhesive for the 3M

Scotch-Weld Hot Melt Applicator PG II LT is

approximately six pounds per hour with 3M™

Scotch-Weld™ Hot Melt Adhesive 3762-LM utilizing

the standard tip 9921. Adhesive flow rates will vary

with the different 3M adhesives in the line and the

nozzle tip you choose.

9727 数据表(PDF) 4 Page - 3M Electronics

9727 数据表(HTML) 4 Page - 3M Electronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

数据表下载