9727 datasheet(5/26 Pages) 3M

5 / 26 page

Setup and Installation

1. Remove the 3M™

Scotch-Weld™ Hot Melt

Applicator PG II LT from its

shipper and inspect for obvious

damage.

2. Connect Air and Electrical

Service

Select a work station where 120 VAC grounded

receptacle and compressed air service are

available.

Grounding Instructions

The 3M Scotch-Weld Hot Melt Applicator PG II LT

must be grounded. If it should malfunction or break

down, grounding provides a path of least resistance

for electric current to help reduce the risk of

electrical shock. This applicator is equipped with a

cord having an equipment-grounding conductor and

grouding plug. This plug must be used with

appropriate outles that are properly installed and

grounded in accordance with all local codes and

ordinances.

The 3M Scotch-Weld Hot Melt Applicator PG II LT

is designed for use on a nominal 120-volt circuit and

has a grounding plug as shown in illustration above.

Make sure the applicator is connected to an outlet

having the same configuration as the plug. No

adaptor should be used.

Danger

Do not modify the plug provided with the 3M

Scotch-Weld Hot Melt Applicator PG II LT.

Improper grounding connection of the plug may

cause electrical shock. Check with a qualified

electrician or service person to determine whether

the plug is properly grounded.

Electrical outlet should be as close to air supply

as possible. Filtered air regulated to 80 psi

maximum is vital to optimum operation.

Important

Do not connect 3M Scotch-Weld Hot Melt

Applicator PG II LT to air supply with air

pressure greater than 80 psi. Damage to the

applicator may result.

Refer to step 3 on page 4 for air filter and

regulator installation procedure.

Connect air hose using two 1/2’’ open-end

wrenches. Remove the steel swivel portion of the

connector and insert the steel swivel into 1/8’’

female pipe thread air source. Insert and tighten

the brass fitting into the swivel and snug up all

fittings.

9727 数据表(PDF) 5 Page - 3M Electronics

9727 数据表(HTML) 5 Page - 3M Electronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

数据表下载