Important Safety Instructions

© 3M 2006

1

!

SAVE THESE INSTRUCTIONS

Read instructions thoroughly before operating or performing any maintenance on 3M™ Scotch-Weld™ Hot

Melt Applicator PG II LT.

Danger

Do not modify the plug provided with the 3M

Scotch-Weld Hot Melt Applicator PG II LT.

Improper grounding connection of the plug may

cause electrical shock. Check with a qualified

electrician or service person to determine whether

the plug is properly grounded.

Caution

Use only an approved extension cord with 3M

Scotch-Weld Hot Melt Applicator PG II LT. Use of

improper extension cord may cause electrical shock.

Use an extension cord that complies with NEC

requirements and state and local electrical

requirements.

Caution

Disconnect air and electrical power and make sure

applicator is at room temperature before servicing

3M Scotch-Weld Hot Melt Applicator PG II LT.

Failure to disconnect air and electrical power before

servicing may cause electrical shock or damage to

the applicator.

Caution

Contact with molten adhesive or hot applicator tip

or metal components may cause burns. Wear heat-

resistant gloves and safety glasses when operating

or repairing the 3M Scotch-Weld Hot Melt

Applicator PG II LT.

Important

Do not connect 3M Scotch-Weld Hot Melt

Applicator PG II LT to air supply with air pressure

greater than 80 psi. Damage to the applicator may

result.

Important

Use 3M™ Scotch-Weld™ Hot Melt LM Adhesives

only. Use of other adhesives may damage the

applicator or result in hazardous conditions.

!

!

!

!

!