installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

In cases where an OEM seeks the lesser category of a Class A digital device for the final product, the following

statement must be included in the final product manual:

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the interference at his expense.

8.2

IC certification

The SPBT3.0DP2 module has been tested and found compliant with the IC RSS-210 rules. These limits are

designed to provide reasonable protection against harmful interference in approved installations. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference may not occur in any particular installation.

This device complies with RSS-210 of the IC rules. Operation is subject to the following two conditions:

1.

this device may not cause harmful interference

2.

this device must accept any interference received, including interference that may cause undesired

operation.

Modifications or changes to this equipment not expressly approved by STMicroelectronics may render void the

user's authority to operate this equipment.

The safe user distance for RF exposure is ≥ 15 mm (in compliance with RSS-102 Issue 5).

Modular approval

IC: 8976C-SPBT302

In accordance with IC RSS-210, the SPBT3.0DP2 is listed as a modular transmitter device.

This module is evaluated for stand-alone use only. Finished products incorporating multiple transmitters must

comply with collocation and RF exposure requirements in accordance with IC multi-transmitter product

procedures. Collocated transmitters operating in portable RF exposure conditions (e.g. <20 cm from persons

including but not limited to body-worn and handheld devices) may require separate approval.

8.2.1

IC labeling instructions

When integrating the SPBT3.0DP2 into the final product, the OEM must ensure that the IC labeling requirements

are satisfied. A statement must be included on the exterior of the final product which indicates that the product

includes a certified module. The label should state the following (or similar wording that conveys the same

meaning):

Contains IC: 8976C-SPBT302

OR

This product contains IC: : 8976C-SPBT302

The OEM must include the following statements on the exterior of the final product unless the product is too small

(e.g. less than 4 x 4 inches):

This device complies with RSS-210 of the IC Rules. Operation is subject to the following two conditions:

1.

this device may not cause harmful interference

SPBT3.0DP2

IC certification

DS11599 - Rev 7

page 22/31