2.

this device must accept any interference received, including any interference that may cause undesired

operation.

8.2.2

Product manual instructions for IC compliance

This section applies to OEM final products containing the SPBT3.0DP2 module, subject to IC compliance. The

final product manual must contain the following statement (or a similar statement that conveys the same

meaning):

Warning: Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment. (RSS-210)

In cases where an OEM seeks Class B (residential) limits for the final product, the following statement must be

included in the final product manual:

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

RSS-210 of the IC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

In cases where an OEM seeks the lesser category of a Class A digital device for the final product, the following

statement must be included in the final product manual:

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

RSS-210 of the IC Rules. These limits are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the interference at his expense.

8.3

Bluetooth certification

Module with embedded stack and profile has been qualified according to SIG qualification rules:

•

Bluetooth SIG Declaration ID: D031101 (subset QDID 84049)

•

Qualified Design ID (QDID): 81857

•

Product type: End Product

•

Core spec version: 3.0

•

Product descriptions: Bluetooth module, spec V3.0

8.4

CE certification

The module has been certified according to the following certification rules:

•

EN 300 328 V 2.1.1 (2016 11) (a)

•

ETSI EN 301 489-17 V3.1.1 (2017-02) (b)

•

ETSI EN 301 489-1 V2.1.1 (2017-02) (c)

•

EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011 + A2:2013 (d)

•

EN 62479:2010

a) EN 300 328 V 2.1.1 (2016 11): “electromagnetic compatibility and radio spectrum Matters (ERM); Wideband

transmission systems; data transmission equipment operating in the 2.4 GHZ ISM band and using wideband

modulation techniques; harmonized EN covering essential requirements under article 3.2 of the R&TTE directive”.

SPBT3.0DP2

Bluetooth certification

DS11599 - Rev 7

page 23/31