PCF8536AT datasheet(29/54 Pages) NXP

29 / 54 page

PCA8576F

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 3 — 3 December 2014

29 of 54

NXP Semiconductors

PCA8576F

Automotive 40 × 4 LCD driver

8.5 I2C-bus controller

The PCA8576F acts as an I2C-bus slave receiver. It does not initiate I2C-bus transfers or

transmit data to an I2C-bus master receiver. The only data output from the PCA8576F are

the acknowledge signals of the selected devices. Device selection depends on the

I2C-bus slave address, on the transferred command data and on the hardware

subaddress.

In single device applications, the hardware subaddress inputs A0 and A1 are normally

tied to VSS which defines the hardware subaddress 0. In multiple device applications A0

and A1 are tied to VSS or VDD using a binary coding scheme, so that no two devices with a

common I2C-bus slave address have the same hardware subaddress.

8.6 Input filters

To enhance noise immunity in electrically adverse environments, RC low-pass filters are

provided on the SDA and SCL lines.

8.7 I2C-bus protocol

Two I2C-bus slave addresses (0111 000 and 0111 001) are used to address the

PCA8576F. The entire I2C-bus slave address byte is shown in Table 18.

The PCA8576F is a write-only device and will not respond to a read access, therefore bit

0 should always be logic 0. Bit 1 of the slave address byte that a PCA8576F will respond

to, is defined by the level tied to its SA0 input (VSS for logic 0 and VDD for logic 1).

Having two reserved slave addresses allows the following on the same I2C-bus:

• Up to 8 PCA8576F for very large LCD applications

• The use of two types of LCD multiplex drive

The I2C-bus protocol is shown in Figure 24. The sequence is initiated with a START

condition (S) from the I2C-bus master which is followed by one of two possible PCA8576F

slave addresses available. All PCA8576Fs whose SA0 inputs correspond to bit 0 of the

slave address respond by asserting an acknowledge in parallel. This I2C-bus transfer is

ignored by all PCA8576Fs whose SA0 inputs are set to the alternative level.

Table 18.

I2C slave address byte

Slave address

Bit

MSB

LSB

SA0

R/W

PCF8536AT 数据表(PDF) 29 Page - NXP Semiconductors

PCF8536AT 数据表(HTML) 29 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54

数据表下载