DS12667 Rev 6

23/33

L99MOD51XP

Functional description of the SPI

32

5.4

Serial Data Out (DO)

The data output driver is activated by a logical low level at the CSN input and will go from

high impedance to a low or high level depending on the status bit 0 (fault condition). The first

rising edge of the CLK input after a high to low transition of the CSN pin will transfer the

content of the selected status register into the data out shift register. Each subsequent

falling edge of the CLK will shift the next bit out.

5.5

Serial clock (CLK)

The CLK input is used to synchronize the input and output serial bit streams. The data input

(DI) is sampled at the rising edge of the CLK and the data output (DO) will change with the

falling edge of the CLK signal.

5.6

Input data register

The device has two input registers. The first bit (bit 0) at the DI-input is used to select one of

the two input registers. All bits are first shifted into an input shift register. After the rising

edge of CSN the contents of the input shift register will be written to the selected input data

register only if a frame of exact 16 data bits is detected. Depending on bit 0 the content of

the selected status register will be transferred to DO during the current communication

frame. Bit 1-8 control the behavior of the corresponding driver. The bits 9,10 and 11 are

used to control the current monitor multiplexer. Bit 15 is used to reset all status bits in both

status registers. The bits in the status registers are cleared after the current communication

frame (rising edge of CSN).

5.7

Status register

This device uses two status registers to store and to monitor the state of the device. Bit 0 is

used as a fault bit and is a logical-NOR combination of bits 1-14 in both status registers. The

state of this bit can be polled by the microcontroller without the need of a full SPI-

communication cycle (see Figure 8.). If one of the over-current bits is set, the corresponding

driver will be disabled. If the over-current recovery bit of the output is not set the

microcontroller has to clear the over-current bit to enable the driver. If the thermal shutdown

bit is set, all drivers go into a high impedance state. Again the microcontroller has to clear

the bit to enable the drivers.