DSPIC30F datasheet(149/220 Pages) MICROCHIP

149 / 220 page

 2004 Microchip Technology Inc.

Preliminary

DS70116C-page 147

dsPIC30F5011/5013

Any interrupt that is individually enabled (using the cor-

responding IE bit) and meets the prevailing priority level

will be able to wake-up the processor. The processor will

process the interrupt and branch to the ISR. The Sleep

status bit in the RCON register is set upon wake-up.

All Resets will wake-up the processor from Sleep

mode. Any Reset, other than POR, will set the Sleep

status bit. In a POR, the Sleep bit is cleared.

If the Watchdog Timer is enabled, then the processor

will wake-up from Sleep mode upon WDT time-out. The

Sleep and WDTO status bits are both set.

20.6.2

IDLE MODE

In Idle mode, the clock to the CPU is shutdown while

peripherals keep running. Unlike Sleep mode, the clock

source remains active.

Several peripherals have a control bit in each module

that allows them to operate during Idle.

LPRC Fail-Safe Clock remains active if clock failure

detect is enabled.

The processor wakes up from Idle if at least one of the

following conditions has occurred:

• any interrupt that is individually enabled (IE bit is

‘1’) and meets the required priority level

• any Reset (POR, BOR, MCLR)

• WDT time-out

Upon wake-up from Idle mode, the clock is re-applied

to the CPU and instruction execution begins immedi-

ately, starting with the instruction following the PWRSAV

instruction.

Any interrupt that is individually enabled (using IE bit)

and meets the prevailing priority level will be able to

wake-up the processor. The processor will process the

interrupt and branch to the ISR. The Idle status bit in

the RCON register is set upon wake-up.

Any Reset other than POR will set the Idle status bit.

On a POR, the Idle bit is cleared.

If Watchdog Timer is enabled, then the processor will

wake-up from Idle mode upon WDT time-out. The Idle

and WDTO status bits are both set.

Unlike wake-up from Sleep, there are no time delays

involved in wake-up from Idle.

20.7

Device Configuration Registers

The configuration bits in each device configuration reg-

ister specify some of the Device modes and are

programmed by a device programmer, or by using the

In-Circuit Serial Programming™ (ICSP™) feature of

the device. Each device configuration register is a

24-bit register, but only the lower 16 bits of each regis-

ter are used to hold configuration data. There are four

device configuration registers available to the user:

FOSC (0xF80000): Oscillator Configuration

FWDT (0xF80002): Watchdog Timer

Configuration Register

FBORPOR (0xF80004): BOR and POR

Configuration Register

FGS (0xF8000A): General Code Segment

Configuration Register

The placement of the configuration bits is automatically

handled when you select the device in your device pro-

grammer. The desired state of the configuration bits

may be specified in the source code (dependent on the

language tool used), or through the programming inter-

face. After the device has been programmed, the appli-

cation software may read the configuration bit values

through the table read instructions. For additional infor-

mation, please refer to the Programming Specifications

of the device.

Note:

In spite of various delays applied (TPOR,

TLOCK and TPWRT), the crystal oscillator

(and PLL) may not be active at the end of

the time-out (e.g., for low frequency crys-

tals). In such cases, if FSCM is enabled,

then the device will detect this as a clock

failure and process the clock failure trap, the

FRC oscillator will be enabled and the user

will have to re-enable the crystal oscillator. If

FSCM is not enabled, then the device will

simply suspend execution of code until the

clock is stable and will remain in Sleep until

the oscillator clock has started.

Note:

If the code protection configuration fuse

bits

(FGS<GCP>

and

FGS<GWRP>)

have been programmed, an erase of the

entire

code-protected

device

only

possible at voltages VDD

≥ 4.5V.

DSPIC30F 数据表(PDF) 149 Page - Microchip Technology

DSPIC30F 数据表(HTML) 149 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载

链接网址

DSPIC30F 数据表(PDF) 149 Page - Microchip Technology

DSPIC30F 数据表(HTML) 149 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表 下载

链接网址

数据表下载