USB2502-HT datasheet(6/44 Pages) SMSC

6 / 44 page

2-Port USB 2.0 Hub Controller

Datasheet

Revision 2.1 (12-06-06)

SMSC USB2502

DATASHEET

Chapter 1 General Description

The SMSC 2-Port Hub is fully compliant with the USB 2.0 Specification and will attach to a USB host

as a Full-Speed Hub or as a Full-/High-Speed Hub. The 2-Port Hub supports Low-Speed, Full-Speed,

and High-Speed (if operating as a High-Speed Hub) downstream devices on all of the enabled

downstream ports.

The Hub works with an external USB power distribution switch device to control VBUS switching to

downstream ports, and to limit current and sense over-current conditions.

All required resistors on the USB ports are integrated into the Hub. This includes all series termination

resistors on D+ and D– pins and all required pull-down and pull-up resistors on D+ and D– pins. The

over-current sense inputs for the downstream facing ports have internal pull-up resistors.

Throughout this document the upstream facing port of the hub will be referred to as the upstream port,

and the downstream facing ports will be called the downstream ports.

1.1

OEM Selectable Features

A default configuration is available in the USB2502 following a reset. This configuration may be

sufficient for some applications. Strapping option pins make it possible to modify a limited sub-set of

the configuration options.

The USB2502 may also be configured by an external EEPROM or a microcontroller. When using the

microcontroller interface, the Hub appears as an SMBus slave device. If the Hub is pin-strapped for

external EEPROM configuration but no external EEPROM is present, then a value of ‘0’ will be written

to all configuration data bit fields (the hub will attach to the host with all ‘0’ values).

The 2-Port Hub supports several OEM selectable features:

Operation as a Self-Powered USB Hub or as a Bus-Powered USB Hub.

Operation as a Dynamic-Powered Hub (Hub operates as a Bus-Powered device if a local power

source is not available and switches to Self-Powered operation when a local power source is

available).

Optional OEM configuration via I2C EEPROM or via the industry standard SMBus interface from

an external SMBus Host.

Compound device support (port is permanently hardwired to a downstream USB peripheral device).

Hardware strapping options enable configuration of the following features.

Non-Removable Ports

Port Power Polarity (active high or active low logic)

USB2502-HT 数据表(PDF) 6 Page - SMSC Corporation

USB2502-HT 数据表(HTML) 6 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

数据表下载