SIM800C datasheet(29/52 Pages) SIMCOM

29 / 52 page

Smart Machine Smart Decision

SIM800C_Hardware_Design_V1.02

2015-4-27

HIG H

LO W

IdleR ing

H ang up the call

Establish the call

Figure 25: UART1_RI behaviour of voice calling as a receiver

HIG H

LO W

Idle

120m s

Receive S M S

UR C

Figure 26: UART1_RI behaviour of URC or receive SMS

However, if the module is used as caller, the UART1_RI will remain high. Please refer to the following figure.

HIG H

LO W

Idle

Ring

Establish

the call

H ang up

the call

Idle

Figure 27: UART1_RI behaviour as a caller

4.7. Audio Interfaces

SIM800C provides an analog input (MICP; MICN), which could be used for electret microphone. The module

also provides an analog output (SPKP; SPKN).

Table 12: Audio interface definition

SPKP/SPKN output can directly drive 32Ω receiver.

AT command “AT+CMIC” is used to adjust the input gain level of microphone. AT command “AT+SIDET”

is used to set the side-tone level. In addition, AT command “AT+CLVL” is used to adjust the output gain level.

For more details, please refer to document [1].

Pin name

Pin number

Function

MICP

Audio input positive

MICN

Audio input negative

SPKP

Audio output positive

SPKN

Audio output negative

SIM800C 数据表(PDF) 29 Page - SIMCom

SIM800C 数据表(HTML) 29 Page - SIMCom

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

数据表下载

链接网址

SIM800C 数据表(PDF) 29 Page - SIMCom

SIM800C 数据表(HTML) 29 Page - SIMCom

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

数据表 下载

链接网址

数据表下载