www.ti.com

DIGITAL INTERFACE

ADDRESS BYTE

COMMAND BYTE

TSC2007

SBAS405 – MARCH 2007

The TSC2007 has a 7-bit slave address word. The first five bits (MSBs) of the slave address are factory-preset

input pins (A1-A0) determine the two LSBs of the device address to activate communication. Therefore, a

maximum of four devices with the same preset code can be connected on the same bus at one time.

The A1-A0 address inputs are read whenever an address byte is received, and should be connected to the

after the read/write bit has been received by the slave.

The last bit of the address byte (R/W) defines the operation to be performed. When set to a '1', a read operation

is selected; when set to a ‘0’, a write operation is selected. Following the START condition, the TSC2007

monitors the SDA bus, checking the device type identifier being transmitted. Upon receiving the '10010' code,

the appropriate device select bits, and the R/W bit, the slave device outputs an acknowledge signal on the SDA

line.

MSB

LSB

D7

D6

D5

D4

D3

D2

D1

D0

1

0

0

1

0

A1

A0

R/W

Bit D0: R/W

BIT

NAME

DESCRIPTION

D7-D4

C3-C0

All Converter Function Select bits as detailed in Table 3, except for the setup command ('1011').

00: Power down between cycles. PENIRQ enabled.

01: A/D converter on. PENIRQ disabled.

D3-D2

PD1-PD0

10: A/D converter off. PENIRQ enabled.

11: A/D converter on. PENIRQ disabled.

0: 12-bit (Lower speed referred to as the 2MHz clock).

D1

M

1: 8-bit (Higher speed referred to as the 4MHz clock).

D0

X

Don't care.

(1)

The command byte definition for the setup command is shown in Table 4.

Bits D7-D4: C3-C0—Converter function select bits. These bits select the input to be converted and the

lists the possible converter functions.

Bits D3-D2: PD1-PD0—Power-down bits. These two bits select the power-down mode that the TSC2007 will be

in after the current command completes, as shown in Table 2.

It is recommended to set PD0 = 0 in each command byte to get the lowest power consumption possible. If

multiple X-, Y-, and Z-position measurements will be done one right after another (such as when averaging),

PD0 =1 will leave the touch screen drivers on at the end of each conversion cycle.

Bit D1: M—Mode bit. If M = 0, the TSC2007 is in 12-bit mode. If M = 1, 8-bit mode is selected.

Bit D0: X—Don’t care.

24

Submit Documentation Feedback