| 数据搜索系统,热门电子元器件搜索 |
|
SCF5249 数据表(PDF) 19 Page - Freescale Semiconductor, Inc |
|
|
|||||||||||||||||||||||||||||
SCF5249 数据表(HTML) 19 Page - Freescale Semiconductor, Inc |
|
19 / 56 page ![]() Signal Descriptions SCF5249 Integrated ColdFire® Microprocessor Data Sheet, Rev. 3 Freescale Semiconductor 19 8.7 Bus Buffer Signals As the SCF5249 has a quite complicated slave bus, with the possibility to put DRAM on the bus, put asynchronous memories on the bus, and to put ISA bus peripherals on the bus, it may become necessary to introduce a bus buffer on the bus. The SCF5249 has a glueless interface to steer these bus buffers with 2 bus buffer output signals BUFENB1/GPIO57 and BUFENB2/GPIO7. NOTE The BUFENB2 signal is only used in the 160 MAPBGA package. 8.8 I2C Module Signals There are two I2C interfaces on this device. The I2C module acts as a quick two-wire, bidirectional serial interface between the SCF5249 processor and peripherals with an I2C interface (e.g., LED controller, A-to-D converter, D-to-A converter). When devices connected to the I2C bus drive the bus, they will either drive logic-0 or high-impedance. This can be accomplished with an open-drain output. 8.9 Serial Module Signals The following signals transfer serial data between the two UART modules and external peripherals. All serial module signals can be used as gpi or gpo. The GPIO-FUNCTION and GPIO1-FUNCTION registers must be programmed to determine pin functions of the inputs and outputs. If used as gpo or gpi, UART functionality is lost. Table 6. I2C Module Signals I2c Module Signal Description I2C Serial Clock The SCL/QPSICLK and SCL2/GPIO3 bidirectional signals are the clock signal for first and second I2C module operation. The I2C module controls this signal when the bus is in master mode; all I2C devices drive this signal to synchronize I2C timing. Signals are multiplexed Function select is done via PLLCR register. I2C Serial Data The SDA/QSPI_DIN and SDA2/GPIO55 bidirectional signals are the data input/output for the first and second serial I2C interface. Signals are multiplexed Function select is done via PLLCR register. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |