ICS1893CF datasheet(76/126 Pages) ICST

76 / 126 page

ICS1893CF, Rev. F, 03/01/07

Mar. 2007

Chapter 7 Management Register Set

ICS1893CF Data Sheet - Release

7.12.9 Premature End (bit 17.5)

The Premature End bit indicates to an STA the detection of two consecutive Idles in a 100Base data stream

by the ICS1893CF.

During reception of a valid packet, the ICS1893CF examines each symbol to ensure that the data being

passed to the MAC Interface is error free. If two consecutive Idles are encountered, it indicates this

condition to the MAC by setting this bit.

If this bit is set to a logic:

• Zero, it indicates a Premature End condition has not been detected since either the last read or reset of

this register.

• One, it indicates a Premature End condition was detected in the packet since either the last read or reset

of this register.

This bit is a latching high bit. (For more information on latching high and latching low bits, see Section

7.1.4.1, “Latching High Bits” and Section 7.1.4.2, “Latching Low Bits”.)

Note: This bit has no definition in 10Base-T mode.

7.12.10 Auto-Negotiation Complete (bit 17.4)

The Auto-Negotiation Complete bit is used to indicate to an STA the completion of the Auto-Negotiation

process. When this bit is set to logic:

• Zero, it indicates that the auto-negotiation process is either not complete or is disabled by the Control

• One, it indicates that the ICS1893CF has completed the auto-negotiation process and that the contents

of Management Registers 4, 5, and 6 are valid.

7.12.11 100Base-TX Signal Detect (bit 17.3)

The 100Base-TX Signal Detect bit indicates either the presence or absence of a signal on the Twisted-Pair

Receive pins (TP_RXP and TP_RXN) in 100Base-TX mode. This bit is logic:

• Zero when no signal is detected on the Twisted-Pair Receive pins.

• One when a signal is present on the Twisted-Pair Receive pins.

7.12.12 Jabber Detect (bit 17.2)

Bit 17.2 is functionally identical to bit 1.1. The Jabber Detect bit indicates whether a jabber condition has

occurred. This bit is a 10Base-T function.

7.12.13 Remote Fault (bit 17.1)

Bit 17.1 is functionally identical to bit 1.4.

7.12.14 Link Status (bit 17.0)

Bit 17.0 is functionally identical to bit 1.2.

ICS1893CF 数据表(PDF) 76 Page - Integrated Circuit Systems

ICS1893CF 数据表(HTML) 76 Page - Integrated Circuit Systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载