PPC440SP-RNC667C datasheet(9/85 Pages) AMCC

9 / 85 page

PowerPC 440SP Embedded Processor

Revision 1.23 - Sept 26, 2006

AMCC Proprietary

Data Sheet

PowerPC 440 Processor Core

The PowerPC 440 processor core is designed for high-end applications such as RAID controllers, SAN, iSCSI,

routers, switches, printers, set-top boxes, and so on. It is the first processor core to implement the Book E

PowerPC embedded architecture and the first to use the 128-bit version of IBM’s on-chip CoreConnect Bus

Architecture.

Features include:

• Up to 667MHz operation

• PowerPC Book E architecture

• 32KB I-cache, 32KB D-cache

– Parity on Data and Tag address - checking of parity with error injection

• Three logical regions in D-cache: Locked, Transient, and Normal

• D-cache full-line flush capability

• 41-bit virtual address, 36-bit (64GB) physical address

• Superscalar, out-of-order execution

• Seven-stage pipeline

• Three execution pipelines

• Dynamic branch prediction

• Memory management unit

– 64-entry, full associative, unified TLB with parity

– Separate instruction and data micro-TLBs

– Storage attributes for write-through, cache-inhibited, guarded, and big or little endian

• Debug facilities

– Multiple instruction and data range breakpoints

– Data value compare

– Single step, branch, and trap events

– Non-invasive real-time trace interface

• 24 DSP instructions

– Single cycle multiply and multiply-accumulate

– 32 x 32 integer multiply

Internal Buses

The PowerPC 440SP Embedded Processor features three standard on-chip buses: the Processor Local Bus

(PLB), the On-Chip Peripheral Bus (OPB), and the Device Control Register Bus (DCR). The high performance,

high bandwidth cores such as the PowerPC 440 processor core, the DDR SDRAM memory controller, and the

DDR PCI-X bridge connect to the PLB. The OPB hosts lower data rate peripherals. The daisy-chained DCR

provides a lower bandwidth path for passing status and control information between the processor core and the

other on-chip cores.

The PLB has a Crossbar arbiter that supports data transfer between the PLB master and two slave segments

identified as the Low Latency (LL) and High Bandwidth (HB) segments. The LL segment allows PLB masters CPU

and I2O, that are adversely affected by latency, to communicate with slave devices with minimal latency. The HB

segment allows PLB masters DMA, XOR, and PCI to exchange large blocks of data with SDRAM and PCI without

interfering with the low latency PLB masters.

Bus features include:

•PLB

– 128-bit Data implementation of the PLB architecture

– Separate and simultaneous read and write data paths

– 64-bit address

– Simultaneous control, address, and data phases

– Four levels of pipelining

– Byte enable capability supporting unaligned transfers

PPC440SP-RNC667C 数据表(PDF) 9 Page - Applied Micro Circuits Corporation

PPC440SP-RNC667C 数据表(HTML) 9 Page - Applied Micro Circuits Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85

数据表下载