PM6680 datasheet(10/49 Pages) STMICROELECTRONICS

10 / 49 page

Pin settings

PM6680

10/49

SGND2

Signal ground for analog circuitry. It must be connected to the signal ground

plan of the power supply.

V5SW

Internal 5V regulator bypass connection.

• If V5SW is connected to OUT5 (or to an external 5V supply) and V5SW is

greater than 4.9V, the LDO5 regulator shuts down and the LDO5 pin is

directly connected to OUT5 through a 3

Ω (max) switch.

If V5SW is connected to GND, the LDO5 linear regulator is always on.

LDO5

5V internal regulator output. It can provide up to 100mA peak current. LDO5

pin supplies embedded low side gate drivers and an external load.

VIN

Device supply voltage input and battery voltage sense. A bypass filter (4

Ω

and 4.7

µF) between the battery and this pin is recommended.

CSENSE1

Positive current sense input for the switching section 1. This pin must be

connected through a resistor to the drain of the synchronous rectifier

(RDSON sensing) to obtain a positive current limit threshold for the power

supply controller.

PHASE1

Switch node connection and return path for the high side driver for the

section 1.It is also used as negative current sense input.

HGATE1

High-side gate driver output for section 1. This is the floating gate driver

output.

BOOT1

Bootstrap capacitor connection for the switching section 1. It supplies the

high-side gate driver.

SKIP

Pulse skipping mode control input.

• If the pin is connected to LDO5 the PWM mode is enabled.

• If the pin is connected to GND, the pulse skip mode is enabled.

• If the pin is connected to VREF the pulse skip mode is enabled but the

switching frequency is kept higher than 33KHz (No-audible pulse skip

mode).

EN1

Enable input for the switching section 1.

• The section 1 is enabled applying a voltage greater than 2.4V to this pin.

• The section 1 is disabled applying a voltage lower than 0.8V.

When the section is disabled the High Side gate driver goes low and Low

Side gate driver goes high.

PGOOD1

Power Good output signal for the section 1. This pin is an open drain output

and when the output of the switching section 1 is out of +/- 10% of its

nominal value.It is pulled down.

PGOOD2

Power Good output signal for the section 2. This pin is an open drain output

and when the output of the switching section 2 is out of +/- 10% of its

nominal value.It is pulled down.

FB1

Feedback input for the switching section 1. This pin is connected to a

resistive voltage-divider from OUT1 to PGND to adjust the output voltage

from 0.9V to 5.5V.

Table 4.

Pin functions (continued)

N°

Function

PM6680 数据表(PDF) 10 Page - STMicroelectronics

PM6680 数据表(HTML) 10 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

数据表下载