STE2004S datasheet(40/79 Pages) STMICROELECTRONICS

40 / 79 page

Bus interfaces

STE2004S

40/79

Figure 44.

3-lines serial reading sequence

4.3

Parallel interface

The STE2004S selectable parallel interfaces are 68000-series and 8080-series. They are

both an 8-bits bi-directional link between the display driver and the application supervisor.

Both parallel interfaces can be read the I2C driver slave address or the status byte.

4.3.1

68000-series parallel interface

If CS is low after the positive edge of RES, the 68000 parallel interface is ready to receive or

transmit data.

While CS pin is high the 68000 parallel interface is kept in reset.

Write mode

If R/W line is set to 0, data is latched on the E falling edge.

Read mode

When R/W line is set to 1, data is output on the D0-D7 bus on the E rising edge. The data

bus is set in high impedance mode when E is set to logic 0.

The I2C address or status byte is output on D0-D7 bus, according to R bit value.

READING SEQUENCE

Write a "00000000" Instruction

Source 9 pulses on SCLK and

Read the ID Number or the Status Byte On SDOUT

END OF READING SEQUENCE

SDOUT Buffer Configured in High Impedence

LR0080

SDOUT Buffer becomes active (Low Impedence)

note: 1) these data are not read by the display Diver

2) SDIN and SDOUT can be short circuited if the processor can configure

serial output buffers in high impedence during data read

STE2004S 数据表(PDF) 40 Page - STMicroelectronics