8.3.2.2 CC Digital Filter

The CC digital filter generates a 16-bit conversion value from the delta-sigma CC front end. Its FIR filter uses the

HFO clock output. New conversions are available every 1 s.

8.3.2.3 ADC Multiplexer

The ADC multiplexer provides selectable connections to the following:

External pins BAT, BAT_SNS, TS

Internal temperature sensor

Internal reference voltages

Internal 1.8-V regulator

VSS ground reference input

In addition, the multiplexer can independently enable the TS input connection to the internal thermistor biasing

circuitry, and enables the user to short the multiplexer inputs for test and calibration purposes.

8.3.2.4 Analog-to-Digital Converter (ADC)

The second ADC is a 16-bit delta-sigma converter designed for general-purpose measurements. The ADC

automatically scales the input voltage range during sampling based on channel selection. The converter

resolution is a function of its full-scale range and number of bits, yielding a 38-µV resolution.

8.3.2.5 Internal Temperature Sensor

An internal temperature sensor is available on the BQ27Z561-R2 device to reduce the cost, power, and size of

the external components necessary to measure temperature. It is available for connection to the ADC using the

multiplexer, and is ideal for quickly determining pack temperature under a variety of operating conditions.

8.3.2.6 External Temperature Sensor Support

The TS input is enabled with an internal 18-kΩ (typical) linearization pullup resistor to support the use of a

10-kΩ (25°C) NTC external thermistor, such as the Semitec 103AT-2. The NTC thermistor should be connected

between VSS and the individual TS pin. The ADC, through its input multiplexer, then takes the analog

measurement. If a different thermistor type is required, then changes to configurations might be required.

REG18

ADC

TS

NTC

Figure 8-1. External Thermistor Biasing

8.3.3 Power Supply Control

The BQ27Z561-R2 device uses the BAT pin as its power source. BAT powers the internal voltage sources that

supply references for the device. BAT_SNS is a noncurrent carrying path and used at the Kelvin reference for

BAT.

BQ27Z561-R2

SLUSE22B – FEBRUARY 2020 – REVISED NOVEMBER 2022

www.ti.com

12

Submit Document Feedback

Copyright © 2022 Texas Instruments Incorporated

Product Folder Links: BQ27Z561-R2