TLV2172IDRG4 datasheet(22/49 Pages) TI2

22 / 49 page

TLV172, TLV2172, TLV4172

SBOS784C – NOVEMBER 2016 – REVISED JANUARY 2019

www.ti.com

Product Folder Links: TLV172 TLV2172 TLV4172

Submit Documentation Feedback

10 Power Supply Recommendations

The TLVx172 is specified for operation from 4.5 V to 36 V (±2.25 V to ±18 V); many specifications apply from

–40°C to +125°C. Parameters that can exhibit significant variance with regard to operating voltage or

temperature are shown in the Typical Characteristics section.

CAUTION

Supply voltages larger than 40 V can permanently damage the device; see the

Absolute Maximum Ratings table.

Place 0.1-μF bypass capacitors close to the power-supply pins to reduce errors coupling in from noisy or high-

impedance power supplies. For more detailed information on bypass capacitor placement, see the Layout

section.

11 Layout

11.1 Layout Guidelines

For best operational performance of the device, use good printed circuit board (PCB) layout practices, including:

•

Noise can propagate into analog circuitry through the power pins of the circuit as a whole and the

operational amplifier itself. Bypass capacitors are used to reduce the coupled noise by providing low-

impedance power sources local to the analog circuitry.

–

Connect low-ESR, 0.1-µF ceramic bypass capacitors between each supply pin and ground, placed as

close to the device as possible. A single bypass capacitor from V+ to ground is applicable for single-

supply applications.

•

Separate grounding for analog and digital portions of the circuitry is one of the simplest and most-

effective methods of noise suppression. One or more layers on multilayer PCBs are usually devoted to

ground planes. A ground plane helps distribute heat and reduces electromagnetic interference (EMI)

noise pickup. Make sure to physically separate digital and analog grounds, paying attention to the flow of

the ground current.

•

In order to reduce parasitic coupling, run the input traces as far away from the supply or output traces as

possible. If these traces cannot be kept separate, crossing the sensitive trace perpendicularly is much

better than in parallel with the noisy trace.

•

Place the external components as close to the device as possible. As shown in Figure 33, keeping RF

and RG close to the inverting input minimizes parasitic capacitance.

•

Keep the length of input traces as short as possible. Always remember that the input traces are the most

sensitive part of the circuit.

•

Consider a driven, low-impedance guard ring around the critical traces. A guard ring can significantly

reduce leakage currents from nearby traces that are at different potentials.

TLV2172IDRG4 数据表(PDF) 22 Page - Texas Instruments

TLV2172IDRG4 数据表(HTML) 22 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

数据表下载