Detailed Description

The MAX9621, an interface between two 2-wire Hall-

effect sensors and a low-voltage microprocessor, supplies

and monitors current through IN1 and IN2 to two Hall

sensors.

The MAX9621 complements Maxim’s existing family of

Hall-effect sensor interfaces that includes the MAX9921.

The MAX9621 provides two independent channels with

two outputs for each channel, a digital output, and an

analog output. The digital outputs (DOUT1 and DOUT2)

are open-drain and indicate a logic level that corresponds

to the Hall sensor status. DOUT1 or DOUT2 outputs high

when the current out of IN1 or IN2, respectively, exceeds

the high-input current threshold. DOUT1 or DOUT2

outputs low when the current flowing out of IN1 or IN2,

respectively, is lower than the low-input current threshold.

DOUT1 and DOUT2 provide a time domain output filter

for robust noise immunity. See Figure 2.

The analog outputs (AOUT1 and AOUT2) mirror the cur-

rent flowing out to the corresponding inputs IN1 and IN2

with a nominal gain of 0.05mA/mA.

Hall Sensor Protection

from Supply Transients

The MAX9621 protects the hall sensors from supply

transients by shutting off current at IN1 and IN2 when the

BAT voltage is 18V. The digital outputs go low and analog

outputs have zero output current. When VBAT returns to

the proper operating range, both inputs restart following

a blanking cycle.

PIN

NAME

FUNCTION

6

DOUT2

Open-Drain Output. Signal translated from Hall sensor 2. DOUT2 is high when the current flowing out of

IN2 exceeds the input current threshold high, and is low when less than the input current threshold low. See

Table 1 for output response to operating conditions.

7

AOUT2

Analog Current Output. Mirrors the current to the corresponding Hall sensor at IN2. When IN2 has been

shut down due to a short to GND a current of zero is supplied to AOUT2. See Table 1 for output response to

operating conditions. To obtain a voltage output, connect a resistor from AOUT_ to ground.

8

DOUT1

Open-Drain Output. Signal translated from Hall sensor 1. DOUT1 is high when the current flowing out of

IN1 exceeds the input current threshold high, and is low when less than the input current threshold low. See

Table 1 for output response to operating conditions.

9

AOUT1

Analog Current Output. Mirrors the current to the corresponding Hall sensor at IN1. When IN1 has been

shut down due to a short to GND a current of zero is supplied to AOUT1. See Table 1 for output response to

operating conditions. To obtain a voltage output, connect a resistor from AOUT_ to ground.

10

SLEEP

Sleep Mode Input. The part is placed in sleep mode when the SLEEP input is low for more than 40µs. If the

SLEEP

input is low for less than 20µs and then goes high, the part restarts any Hall input that has been shut

off due to a detected short to GND. Any Hall input that is operational is not affected when SLEEP is cycled

low for less than 20µs. There is an internal 100kΩ pulldown resistance to GND.

MAX9621

Dual, 2-Wire Hall-Effect Sensor Interface

with Analog and Digital Outputs

www.maximintegrated.com

Maxim Integrated │ 11

Pin Description (continued)