TLV9032DDFR.A datasheet(25/85 Pages) TI2

25 / 85 page

7.1.1.3 Overdrive Voltage

The overdrive voltage, VOD, is the amount of input voltage beyond the reference voltage (and not the total input

peak-to-peak voltage). The overdrive voltage is 100mV as shown in the Figure 7-1 example. The overdrive

voltage can influence the propagation delay (tp). The smaller the overdrive voltage, the longer the propagation

delay, particularly when <100mV. If the fastest speeds are desired, TI recommends applying the highest amount

of overdrive possible.

The risetime (tr) and falltime (tf) is the time from the 20% and 80% points of the output waveform.

7.1.2 Hysteresis

The basic comparator configuration can oscillate or produce a noisy chatter output if the applied differential input

voltage is near the offset voltage of the comparator. This typically occurs when the input signal moves very

slowly across the switching threshold of the comparator.

the addition of hysteresis or positive feedback prevents this problem.

The hysteresis transfer curve is shown in Figure 7-2. This curve is a function of three components: VTH, VOS,

and VHYST:

• VTH is the actual set voltage or threshold trip voltage.

• VOS is the internal offset voltage between VIN+ and VIN–. This voltage is added to VTH to form the actual trip

point at which the comparator must respond to change output states.

• VHYST is the hysteresis (or trip window) that is designed to reduce comparator sensitivity to noise.

VTH + VOS ± (VHYST / 2)

VTH + VOS + (VHYST / 2)

VTH + VOS

Figure 7-2. Hysteresis Transfer Curve

For more information, see the Comparator with and without hysteresis circuit application note.

7.1.2.1 Inverting Comparator With Hysteresis

The inverting comparator with hysteresis requires a three-resistor network that is referenced to the comparator

supply voltage (V+), as shown in Figure 7-3.

1 0Ÿ

+VCC

+5 V

VIN

1 0Ÿ

5 V

0 V

VA2

VA1

1.67 V

3.33 V

VIN

Figure 7-3. TLV903xin an Inverting Configuration With Hysteresis

The equivalent resistor networks when the output is high and low are shown in Figure 7-3.

www.ti.com

TLV9020, TLV9021, TLV9022, TLV9024, TLV9030, TLV9031, TLV9032, TLV9034

SNOSDA3H – JUNE 2020 – REVISED NOVEMBER 2025

Submit Document Feedback

Product Folder Links: TLV9020 TLV9021 TLV9022 TLV9024 TLV9030 TLV9031 TLV9032 TLV9034

TLV9032DDFR.A 数据表(PDF) 25 Page - Texas Instruments

TLV9032DDFR.A 数据表(HTML) 25 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85

数据表下载