PSD211R datasheet(26/51 Pages) STMICROELECTRONICS

26 / 51 page

PSD211R Family

15.0

Security Mode

Security Mode in the PSD211R locks the contents of PAD A, PAD B, and all the

configuration bits. The EPROM and I/O contents can be accessed only through the PAD.

The Security Mode must be set by PSDsoft prior to run-time. The Security Bit can only be

erased on the UV parts using a full-chip erase. If Security Mode is enabled, the contents of

the PSD211R can not be uploaded (copied) on a device programmer.

16.0

Power

Management

PSDs from all 211R families use zero-power memory techniques that place memory into

Standby Mode between MCU accesses. The memory becomes active briefly after an

address transition, then delivers new data to the outputs, latches the outputs, and returns to

Standby. This is done automatically and the designer has to do nothing special to benefit

from this feature.

In addition to the benefits of Zero-power memory technology, there are ways to gain

additional savings. The following factors determine how much current the entire PSD device

uses:

• Use of CSI (Chip Select Input)

• Setting of the CMiser bit

• Setting of the Turbo Bit (ZPSD only)

• The number of product terms used in the PAD

• The composite frequency of the input signals to the PAD

• The loading on I/O pins.

The total current consumption for the PSD is calculated by summing the currents from

memory, PAD logic, and I/O pins, based on your design parameters and the power

management options used.

16.1 CSI Input

Driving the CSI pin inactive (logic 1) disables the inputs of the PSD and forces the entire

PSD to enter Power-down Mode, independent of any transition on the MCU bus (address

and control) or other PSD inputs. During this time, the PSD device draws only standby

current (micro-amps). Alternately, driving a logic 0 on the CSI pin returns the PSD to normal

operation. See Tables 7A and 7B for information on signal states during Power-down Mode.

The CSI pin feature is available only if enabled in the PSDsoft Configuration utility.

16.2 CMiser bit

In addition to power savings resulting from the Zero-power technology used in the memory,

the CMiser feature saves even more power under certain conditions. Savings are

significant when the PSD is configured for an 8-bit data path because the CMiser feature

turns off half of the array when memory is being accessed (the memory is divided internally

into odd and even arrays). See the DC characteristics table for current usage related to the

CMiser bit.

You should keep the following in mind when using this bit:

• Setting of this bit is accomplished with PSDsoft at the design stage, prior to run-time.

• Memory access times are extended by 10 nsec for standard voltage (non-V) devices,

and 20 nsec for low voltage (V) devices.

PSD211R 数据表(PDF) 26 Page - STMicroelectronics

PSD211R 数据表(HTML) 26 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51

数据表下载