FZ-SSLASHSC datasheet(38/54 Pages) OMRON

38 / 54 page

FH-Series

* Use the attachment power terminal connector (male) of FH-XCN-L series.

For details, refer to 5-3 Sensor Controller Installation on Vision System FH series Hardware Setup Manual(Z366).

LED name

Description

[1]

PWR LED

Lit while power is ON.

[2]

ERROR LED

Lit when an error has occurred.

[3]

RUN LED

Lit while the layout turned on output setting is displayed.

[4]

ACCESS LED

Blinks while the internal nonvolatile memory is accessed.

[5]

SD PWR LED

Lit while power is supplied to the SD memory card and the card is usable.

[6]

SD BUSY LED

Lit when access to the SD memory card.

[7]

Ethernet NET RUN LED

Lit while Ethernet communications are usable.

[8]

Ethernet LINK/ACT LED

Blinks when connected with an Ethernet device, and blinks while performing communications.

Connector name

Description

SD memory card installation

connector

Install the SD memory card. Do not plug or unplug the SD memory card during measurement operation.

Otherwise measurement time may be affected or data may be destroyed.

USB 2.0 connector

Connects to USB 2.0. Do not insert or remove during loading or writing of measurement or data.

The measurement time can be longer or data can be damaged.

USB 3.0 connector

Connects to USB 3.0. Do not insert or remove during loading or writing of measurement or data.

The measurement time can be longer or data can be damaged.

USB 3.0 has a high ability to supply the bus power.

Use the Sensor Controller by combining USB 3.0, faster transport can be realized.

Ethernet connector

Connect an Ethernet device.

Ethernet port, EtherNet/IP port, and PROFINET port are sharing use.

RS-232C connector

Connect an external device such as a programmable controller.

DVI-I connector

Connect a monitor.

Parallel connector

(control lines, data lines)

Connect the controller to external devices such as a sync sensor.

Camera connector

Connect a camera.

Power supply terminal connector

Connect a DC power supply. Wire the controller independently on other devices. Wire * the ground line.

Be sure to ground the FH Sensor Controller alone.

[1]

[3]

[5]

[2]

[4]

[6]

[7]

[8]

Lite Controllers

(4-camera type)

FZ-S/SC 数据表(PDF) 38 Page - Omron Electronics LLC

FZ-S/SC 数据表(HTML) 38 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54

数据表下载