T410 datasheet(33/84 Pages) STMICROELECTRONICS

部件名	T410

功能描述	8-BIT INTELLIGENT CONTROLLER UNIT ICU Three Timer/PWMs, ADC, WDG

PDF	84 Pages

Scroll/Zoom	100%

制造商	STMICROELECTRONICS [STMicroelectronics]

网页	http://www.st.com

标志

33 / 84 page

ST52T410/ST52T420/E420

33/84

4.6 Interrupts and Low power mode

All interrupts allow the processor to leave the WAIT

low power mode. Only the external Interrupt allows

the processor to leave the HALT low power mode.

4.7 Interrupt RESET

An eventually pending interrupt can be reset with

the instruction RINT j, which resets the interrupt

j-th where j identifies the peripherals as described

in thefollowing table(seeTable4.4).

The assembler instruction:

RINT 2

Resets the PWM/Timer 1 interrupt.

Note: The RINT command must be preceded

from a UDGI (or MDGI) command and followed

by a UEGI (or MEGI) command.

WARNING: If an interrupt is reset, with the RINT

instruction within its own interrupt routine, the

priority level of the interrupt becomes the

lowest and the routine can be immediately

interrupted

lower

priority

interrupt

request.

T410 数据表(PDF) 33 Page - STMicroelectronics