ST6208LD3SLASHOTP datasheet(62/104 Pages) STMICROELECTRONICS

62 / 104 page

ST6208C/ST6209C/ST6210C/ST6220C

62/104

10 ELECTRICAL CHARACTERISTICS

10.1 PARAMETER CONDITIONS

Unless otherwise specified, all voltages are re-

ferred to VSS.

10.1.1 Minimum and Maximum Values

Unless otherwise specified the minimum and max-

imum values are guaranteed in the worst condi-

tions of ambient temperature, supply voltage and

frequencies by tests in production on 100% of the

devices with an ambient temperature at TA=25°C

and TA=TAmax (given by the selected temperature

range).

Data based on characterization results, design

simulation and/or technology characteristics are

indicated in the table footnotes and are not tested

in production. Based on characterization, the min-

imum and maximum values refer to sample tests

and represent the mean value plus or minus three

times the standard deviation (mean±3

Σ).

10.1.2 Typical Values

Unless otherwise specified, typical data are based

on TA=25°C, VDD=5V (for the 4.5V≤VDD≤6.0V

voltage

range)

and

VDD=3.3V

(for

the

≤V

DD≤3.6V voltage range). They are given only

as design guidelines and are not tested.

10.1.3 Typical Curves

Unless otherwise specified, all typical curves are

given only as design guidelines and are not tested.

10.1.4 Loading Capacitor

The loading conditions used for pin parameter

measurement is shown in Figure 36.

Figure 36. Pin Loading Conditions

10.1.5 Pin Input Voltage

The input voltage measurement on a pin of the de-

vice is described in Figure 37.

Figure 37. Pin Input Voltage

ST6 PIN

VIN

ST6 PIN

ST6208LD3/OTP 数据表(PDF) 62 Page - STMicroelectronics

ST6208LD3/OTP 数据表(HTML) 62 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载