ATmega162 datasheet(45/324 Pages) ATMEL

45 / 324 page

2513K–AVR–07/09

ATmega162/V

Power-save Mode

When the SM2..0 bits are written to 011, the SLEEP instruction makes the MCU enter Power-

save mode. This mode is identical to Power-down, with one exception:

If Timer/Counter2 is clocked asynchronously, i.e., the AS2 bit in ASSR is set, Timer/Counter2

will run during sleep. The device can wake up from either Timer Overflow or Output Compare

event from Timer/Counter2 if the corresponding Timer/Counter2 interrupt enable bits are set in

TIMSK, and the Global Interrupt Enable bit in SREG is set.

If the Asynchronous Timer is NOT clocked asynchronously, Power-down mode is recommended

instead of Power-save mode because the contents of the registers in the Asynchronous Timer

should be considered undefined after wake-up in Power-save mode if AS2 is 0.

This sleep mode basically halts all clocks except clk

ASY, allowing operation only of asynchronous

modules, including Timer/Counter 2 if clocked asynchronously.

Standby Mode

When the SM2..0 bits are 110 and an external crystal/resonator clock option is selected, the

SLEEP instruction makes the MCU enter Standby mode. This mode is identical to Power-down

with the exception that the main Oscillator is kept running. From Standby mode, the device

wakes up in six clock cycles.

Extended Standby

Mode

When the SM2..0 bits are 111 and an external crystal/resonator clock option is selected, the

SLEEP instruction makes the MCU enter Extended Standby mode. This mode is identical to

Power-save mode with the exception that the main Oscillator is kept running. From Extended

Standby mode, the device wakes up in six clock cycles.

Notes:

1. External Crystal or resonator selected as clock source

2. If AS

2 bit in ASSR is set

3. For INT1 and INT0, only level interrupt

Table 17. Active Clock domains and Wake up sources in the different sleep modes

Active Clock domains

Oscillators

Wake-up Sources

Sleep Mode

clk

CPU

clk

FLASH

clk

ASY

Main Clock

Source Enabled

Timer Osc

Enabled

INT2

INT1

INT0

and Pin Change

Timer

SPM/

EEPROM

Ready

Other

I/O

Idle

X(2)

Power-down

X(3)

Power-save

X(2)

X(3)

X(2)

Standby(1)

XX(3)

Extended Standby(1)

X(2)

XX(2)

X(3)

X(2)

ATmega162 数据表(PDF) 45 Page - ATMEL Corporation

ATmega162 数据表(HTML) 45 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载

链接网址

ATmega162 数据表(PDF) 45 Page - ATMEL Corporation

ATmega162 数据表(HTML) 45 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表 下载

链接网址

数据表下载