AS3525 datasheet(21/194 Pages) AMSCO

21 / 194 page

AS3525-A/-B C22O22

Data Sheet, Confidential

www.austriamicrosystems.com

Revision 1.13

- 194

Branch Instructions

As well as letting data processing or load instructions change

control flow (by writing the PC) a standard branch instruction is

provided with 24-bit signed offset, providing for forward and

backward branches of up to 32 MB.

A branch with link (BL) instruction enables efficient subroutine

calls. BL preserves the address of the instruction after the

branch in R14 (Link register or LR). This lets a move instruction

put the LR in to the PC and return to the instruction after the

branch.

The branch and exchange (BX) instruction switches between ARM and

Thumb instruction sets with the return address optionally preserving the

operating mode of the calling subroutine.

Coprocessor Instructions

There are three types of coprocessor instructions:

•

Coprocessor data processing instructions

•

Coprocessor register transfer instructions

•

Coprocessor data transfer instructions

7.1.5 JTAG Interface

The ARM933T debug interface is based on IEEE Std. 1149.1- 1990, standard test access port. The ARM922T contains hardware extensions for

advanced debugging features. These are intended to ease the development of application software.

The debug extensions allow the core to be stopped by one of the following:

•

A given instruction fetch (breakpoint)

•

A data access (watchpoint)

•

Asynchronously by a debug request

When this happens, the ARM922T is said to be in debug state. At this point, you can examine the internal state of the core and the external state of

the system. When examination is complete, you can restore the core and system state and resume program execution.

Normally, all control for debugging is done by running a debugger software (ARM AXD or ARM Realview Debugger) on a debug host PC.

Connection to the chip is done by an ARM Multi-ICE interface, which connects either to the parallel port or the USB port of the debug host PC.

The connection to the multi-ICE interface is done via a 20 way connector and ribbon cable. Following diagram shows the signals connections of the

AS3525 to this ICE connector.

Figure 6 Interface connector to multi-ICE

AS3525 数据表(PDF) 21 Page - ams AG

AS3525 数据表(HTML) 21 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载