Obsolete

Product(s)

- Obsolete

Product(s)

CLP200M

19/21

PowerSo-10 package mounted on

P Diss (*)

1.FR4 using the recommended pad-layout

50 °C/W

1.5 W

2.FR4 with heatsink on board (6cm

35 °C/W

2.0 W

3.FR4 with copper-filled through holes and external heatsink applied

12 °C/W

5.8 W

4. IMS floating in air (40 cm

8 °C/W

8.8 W

5. IMS with external heatsink applied

3.5 °C/W

20 W

(*) Based on a delta T of 70 °C junction train.

TABLE 1 : THERMAL IMPEDANCE VERSUS SUBSTRATE

A new technology available today is IMS - an Insu-

lated Metallic Substrate. This offers greatly en-

hanced

thermal

characteristics

for

surface

mount components. IMS is a substrate consisting

of three different layers, (I) the base material which

is available as an aluminium or a copper plate, (II)

a thermal conductive dielectrical layer and (III) a

copper foil, which can be etched as a circuit layer.

Using this material a thermal resistance of 8°C/W

with 40 cm

(see fig. 4). If even higher power is to be dissipated

an external heatsink could be applied which leads

tion-heatsink). This is commonly applied in prac-

tice, leading to reasonable heatsink dimensions.

Often power devices are defined by considering

the maximum junction temperature of the device.

In practice , however, this is far from being ex-

ploited. A summary of various power management

capabilities is made in table 1 based on a reason-

able delta T of 70°C junction to air.

Copper foil

Insulation

Aluminium

Fig4: Mounting on metal backed board

FR4 board

Copper foil

Aluminium

heatsink

Fig5: Mounting on metal backed board with an

external heatsink applied

The PowerSO-10 concept also represents an at-

tractive

alternative

to

C.O.B.

techniques.

PowerSO-10 offers devices fully tested at low and

high temperature. Mounting is simple - only con-

ventional SMT is required - enabling the users to

get rid of bond wire problems and the problem to

control the high temperature soft soldering as well.

An optimized thermal management is guaranteed

through PowerSO-10 as the power chips must in

any case be mounted on heat spreaders before

being mounted onto the substrate.