ADN2526

Rev. A | Page 15 of 16

DESIGN EXAMPLE

This design example covers:

•

Headroom calculations for the IBIAS, IMODP, and

IMODN pins.

•

Calculation of the typical voltage required at the BSET and

MSET pins to produce the desired bias and modulation

currents.

This design example assumes that the resistance of the TOSA is

IBIAS = 40 mA, IMOD = 60 mA, and VCC = 3.3 V.

Headroom Calculations

To ensure proper device operation, the voltages on the IBIAS,

IMODP, and IMODN pins must meet the compliance voltage

specifications in Table 1.

Considering the typical application circuit shown in Figure 34,

the voltage at the IBIAS pin can be written as

where:

VCC is the supply voltage.

For proper operation, the minimum voltage at the IBIAS pin

should be greater than 0.6 V, as specified by the minimum

IBIAS compliance specification in Table 1.

Assuming that the voltage drop across the 25 Ω transmission

40 mA

The maximum voltage at the IBIAS pin must be less than the

maximum IBIAS compliance specification as described by

(2)

For this example,

To calculate the headroom at the modulation current pins

(IMODP and IMODN), the voltage has a dc component equal

to VCC, due to the ac-coupled configuration, and a swing equal

to IMOD × 25 Ω. For proper operation of the ADN2526, the

voltage at each modulation output pin should be within the

normal operation region shown in Figure 30.

modulation output pins is equal to

VCC − (IMOD × 25)/2 = VCC − 0.75

VCC − 0.75 > VCC − 1.1 V, which satisfies the requirement.

The maximum voltage at the modulation pins is equal to

VCC + (IMOD × 25)/2 = VCC + 0.75

VCC + 0.75 < VCC + 1.1 V, which satisfies the requirement.

Headroom calculations must be repeated for the minimum and

maximum values of the required IBIAS and IMOD ranges to

ensure proper device operation over all operating conditions.

BSET and MSET Pin Voltage Calculation

To set the desired bias and modulation currents, the BSET and

MSET pins of the ADN2526 must be driven with the appropriate

dc voltage. The voltage range required at the BSET pin to generate

the required IBIAS range can be calculated using the BSET voltage

to IBIAS gain specified in Table 1. Assuming that IBIAS = 40 mA

is given by

V

4

.

0

100

40

mA/V

100

(mA)

=

=

=

IBIAS

V

BSET

The BSET voltage range can be calculated using the required

IBIAS range and the minimum and maximum BSET voltage to

IBIAS gain values specified in Table 1.

The voltage required at the MSET pin to produce the desired

modulation current can be calculated using

K

IMOD

V

where K is the MSET voltage to IMOD ratio.

The value of K depends on the actual resistance of the TOSA.

It can be read using the plot shown in Figure 29. For a TOSA

resistance of 25 Ω, the typical value of K is equal to 120 mA/V.

Assuming that IMOD = 60 mA and using the preceding

equation, the MSET voltage is given by

V

5

.

0

120

60

mA/V

120

(mA)

=

=

=

IMOD

V

MSET

The MSET voltage range can be calculated using the required

IMOD range and the minimum and maximum K values. These

can be obtained from the minimum and maximum curves in

Figure 29.