LTM4627EVPBF datasheet(22/28 Pages) LINER

22 / 28 page

LTM4627

4627f

APPLICATIONS INFORMATION

Safety Considerations

The LTM4627 modules do not provide isolation from VIN

to VOUT. There is no internal fuse. If required, a slow blow

fuse with a rating twice the maximum input current needs

to be provided to protect each unit from catastrophic

failure. The device does support overvoltage protection

and overcurrent protection.

Layout Checklist/Example

The high integration of the LTM4627 makes the PCB

board layout very simple and easy. However, to optimize

its electrical and thermal performance, some layout con-

siderations are still necessary.

• Use large PCB copper areas for high current paths,

including VIN, GND and VOUT. It helps to minimize the

PCB conduction loss and thermal stress.

• Place high frequency ceramic input and output capaci-

tors next to the VIN, GND and VOUT pins to minimize

high frequency noise.

• Place a dedicated power ground layer underneath the

unit.

• To minimize the via conduction loss and reduce module

thermal stress, use multiple vias for interconnection

between top layer and other power layers.

• Do not put vias directly on the pad, unless they are

capped or plated over.

• Place test points on signal pins for testing.

• Use a separated SGND ground copper area for com-

ponents connected to signal pins. Connect the SGND

to GND underneath the unit.

• For parallel modules, tie the COMP and VFB pins to-

gether. Use an internal layer to closely connect these

pins together. Figure 17 gives a good example of the

recommended layout.

Figure 17. Recommended PCB Layout

GND

VIN

4627 F17

CONTROL

SIGNAL

GROUND

VOUT

COUT

CIN

LTM4627EVPBF 数据表(PDF) 22 Page - Linear Technology

LTM4627EVPBF 数据表(HTML) 22 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

数据表下载