ST802RT1B datasheet(21/58 Pages) STMICROELECTRONICS

21 / 58 page

ST802RT1A, ST802RT1B

Registers and descriptors description

Doc ID 17049 Rev 1

21/58

Table 11.

RN01 [0d01, 0x01]: Status register

Bit

Bit name

Description

Default

type

Type

100BASE-T4

ABILITY

0 -> PHY not able to perform 100BASE-T4

Fixed to 0

0RO

100BASE-X

Full Duplex

1 -> PHY able to perform full-duplex 100BASE-X

Fixed to 1, internally not used

1RO

100BASE-X

Half Duplex

1 -> PHY able to perform half-duplex 100BASE-X

Fixed to 1

1RO

10BASE-T

Full Duplex

1 -> PHY able to perform full-duplex 10BASE-T

Fixed to 1, internally not used

1RO

10BASE-T

Half Duplex

1 -> PHY able to perform half-duplex 10BASE-T

Fixed to 1

1RO

RESERVED

Not used

RESERVED

Not used

RESERVED

Not used

RESERVED

Not used

MF Preamble

Suppression

1 -> Accepts management frames with preamble suppressed

0 -> Doesn't accept management frames without preamble

Controlled by RN14 [1].

1RO

Auto-

Negotiation

complete

1 -> Auto-negotiation process completed, registers 4, 5, 6 are now

valid

0 -> Auto-negotiation process not completed

Active only if auto-negotiation is enabled, else 0

0RO

Remote Fault

1 -> Remote fault condition detected

0 -> No remote fault condition detected

Set when link partner signals a remote fault condition (RN05 - bit

13) or a far-end-fault indicator was asserted. Latched, so the

occurrence of a remote fault causes the remote fault bit to become

set and remain set until it is cleared (by register read, if no more

fault is present).

0RO

Auto-

Negotiation

Ability

1 -> PHY is able to perform auto-negotiation

Fixed to 1

1RO

Link Status

1 -> Link is valid and established (either for 10 and 100 Mb/s)

0 -> Link is down

This bit is cleared at link failure and set after a register read if a

valid link is established

0RO

Jabber Detect

1 -> Jabber condition detected: transmission exceeded max

number of bytes

0 -> No jabber condition detected.

Set at jabber condition detection, cleared only after register read

(if no more jabber condition is present).

Working on 10Base-T only. Fixed to 0 in 100Base-X modes

0RO

Extended

Capability

1 -> extended register capabilities

Fixed to 1

1RO

ST802RT1B 数据表(PDF) 21 Page - STMicroelectronics

ST802RT1B 数据表(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

数据表下载

链接网址

ST802RT1B 数据表(PDF) 21 Page - STMicroelectronics

ST802RT1B 数据表(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

数据表 下载

链接网址

数据表下载