WI.232FHSS-25-R datasheet(36/67 Pages) RADIOMETRIX

36 / 67 page

WI.232FHSS-25-R/ WI.232FHSS-250-R DATASHEET

Revision 1.1.0

4.1.3. Power Mode (regPWRMODE)

regNVPWRMODE (0x02)

regPWRMODE (0x4D)

R/W

PM1

PM0

Default Power Mode: High Power

The following table shows the available power settings and typical power outputs for the Wi.232FHSS-25-R

and Wi.232FHSS-250-R:

PM1

PM0

WI.232FHSS-250-R

WI.232FHSS-25-R

Low (+8 dBm)

Low (-2 dBm)

Mid - Low (+13 dBm)

Mid - Low (+3 dBm)

Mid - High (+18 dBm)

Mid - High (+8 dBm)

High (+23.5 dBm)

High (+13 dBm)

Table 11, Power Mode Register Settings

Wi.232FHSS-25-R modules transmitting at high power in close proximity of one another may cause an

increase in data loss. The Wi.232FHSS-250-R incorporates on-board AGC circuitry to mitigate this effect.

4.1.4. UART Data Rate (regUARTDATARATE)

regNVUARTDATARATE (0x03)

regUARTDATARATE (0x4E)

R/W

RES

BR2

BR1

BR0

Default UART Data Rate: 2400 baud

Changing the value in regNVUARTDATARATE will change the default data rate at power-on or following a

reset (wake from deep sleep is not considered a reset). Changing regUARTDATARATE will change the

current data rate immediately following the command acknowledgment. Valid settings are:

Baud Rate

BR2

BR1

BR0

2400

9600

19200

38400

57600

115200

10400

31250

Table 12, Data Rate Register Settings

WI.232FHSS-25-R 数据表(PDF) 36 Page - Radiometrix Ltd

WI.232FHSS-25-R 数据表(HTML) 36 Page - Radiometrix Ltd

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67

数据表下载