STA335W datasheet(13/43 Pages) STMICROELECTRONICS

13 / 43 page

STA335W

I2C bus specification

13/43

I2C bus specification

The STA335W supports the I2C protocol via the input ports SCL and SDA_IN (master to

slave) and the output port SDA_OUT (slave to master). This protocol defines any device

that sends data on to the bus as a transmitter and any device that reads the data as a

receiver. The device that controls the data transfer is known as the master and the other as

the slave. The master always starts the transfer and provides the serial clock for

synchronization. STA335W is always a slave device in all of its communications. It supports

up to 400 kb/s rate (fast-mode bit rate). STA335W I2C is a slave only interface.

4.1

Communication protocol

4.1.1

Data transition or change

Data changes on the SDA line must only occur when the SCL clock is low. SDA transition

while the clock is high is used to identify a START or STOP condition.

4.1.2

Start condition

START is identified by a high to low transition of the data bus SDA signal while the clock

signal SCL is stable in the high state. A START condition must precede any command for

data transfer.

4.1.3

Stop condition

STOP is identified by low to high transition of the data bus SDA signal while the clock signal

SCL is stable in the high state. A STOP condition terminates communication between

STA335W and the bus master.

4.1.4

Data input

During the data input the STA335W samples the SDA signal on the rising edge of clock

SCL. For correct device operation the SDA signal must be stable during the rising edge of

the clock and the data can change only when the SCL line is low.

4.2

Device addressing

To start communication between the master and the STA335W, the master must initiate with

a start condition. Following this, the master sends onto the SDA line 8-bits (MSB first)

corresponding to the device select address and read or write mode.

The seven most significant bits are the device address identifiers, corresponding to the I2C

bus definition. In the STA335W the I2C interface has two device addresses depending on

the SA port configuration, 0x38 when SA = 0, and 0x3A when SA = 1.

The eighth bit (LSB) identifies read or write operation RW, this bit is set to 1 in read mode

and to 0 for write mode. After a START condition the STA335W identifies on the bus the

device address and if a match is found, it acknowledges the identification on SDA bus

during the 9th bit time. The byte following the device identification byte is the internal space

address.

STA335W 数据表(PDF) 13 Page - STMicroelectronics

STA335W 数据表(HTML) 13 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

数据表下载