SLAS191A datasheet(32/86 Pages) TI

32 / 86 page

1–26

VPP -Input

Apply If

programming via serial

port

VPP fuse F250 mA

Connects to programming

adapter MSP-PRG430x

(EVK only)

Jumper for programming the EPROM

of an EVK with the Monitor

Figure 1–22. Programming Voltage and Jumper Location

To load a program into the MSP430 EPROM/ROM using the HyperTerminal, the following points must be

considered:

•

The Monitor code must already be programmed into the EPROM/ROM (only the EVK is supplied

with the code for the monitor program mon_x.txt).

•

The STK/EVK 9-pin D-SUB-connector must be connected to the serial interface (the default is

COM2) of the PC.

•

The supply voltages of the STK/EVK must be applied by connecting the STK/EVK to the serial

interface of the PC and by connecting the programming supply voltage.

NOTE: Programming the EVK using the Serial Port

Attach a jumper between PIN 13 and PIN 14 on the Programming Adapter connector (see

Hardware Installation in Chapter 9).

If the assembled file gs_stk5.asm is downloaded, the program routines for the LCD, and the interrupt routine

of the previous example will be written into the EPROM/ROM (see sections in the code).

SLAS191A 数据表(PDF) 32 Page - Texas Instruments