A7986ATR datasheet(28/42 Pages) STMICROELECTRONICS

28 / 42 page

Application information

A7986A

28/42

DocID022801 Rev 5

Figure 16. Switching losses

6.6

Layout considerations

The PC board layout of switching DC-DC regulator is very important to minimize the noise

injected in high impedance nodes and interference generated by the high switching current

loops.

In a step-down converter the input loop (including the input capacitor, the power MOSFET

and the freewheeling diode) is the most critical one. This is due to the fact that the high

value pulsed current is flowing through it. In order to minimize the EMI, this loop must be as

short as possible.

The feedback pin (FB) connection to the external resistor divider is a high impedance node,

so the interference can be minimized by placing the routing of the feedback node as far as

possible from the high current paths. To reduce the pick-up noise, the resistor divider must

be placed very close to the device.

To filter the high frequency noise, a small bypass capacitor (220 nF - 1 µF) can be added as

close as possible to the input voltage pin of the device.

Thanks to the exposed pad of the device, the ground plane helps to reduce the thermal

resistance junction to ambient; so a large ground plane enhances the thermal performance

of the converter allowing high power conversion.

In Figure 17, a layout example is shown.

A7986ATR 数据表(PDF) 28 Page - STMicroelectronics