HVLED807PF datasheet(30/36 Pages) STMICROELECTRONICS

30 / 36 page

Device description

HVLED807PF

30/36

Doc ID 023464 Rev 5

Equation 24

where VCLED is internally defined (0.2 V typical - see Table 5: Electrical characteristics).

System design tips

Starting from the estimated value using the previous formulas, further fine-tuning on the real

led driver board could be necessary and it can be easily done considering that:

–

Decreasing/increasing the RPF resistor value, the power factor effect

increase/decrease

–

Decreasing/increasing the ROS resistor value, the line-regulation effect

increase/decrease

–

Decreasing/increasing the ROS resistor value, the RA+RB resistors value should

be increase/decrease to keep the desiderated voltage across the COS capacitor

(Equation

22).

–

Decreasing/increasing the RSENSE resistor value the average output current

increase/decrease (Equation

24).

4.12

Layout recommendations

A proper printed circuit board layout is essential for correct operation of any switch-mode

converter and this is true for the HVLED815PF as well. Careful component placing, correct

traces routing, appropriate traces widths and compliance with isolation distances are the

major issues.

In particular:

●

Current sense resistor (RSENSE) should be connected as close as possible to the

SOURCE pin, maintaining the trace for the GND as short as possible.

●

Resistor connected on CS pin (ROS, RPF, R1) should be connected as close as possible

to the pin.

●

Compensation network (RCOMP, CCOMP) should be connected as close as possible to

the COMP pin, maintaining the trace for the GND as short as possible.

●

Signal ground should be routed separately from power ground, as well from the sense

resistor trace.

●

DMG partition resistors (RDMG, RFB) should be connected as close as possible to the

DMG pin, minimizing the equivalent parasitic capacitor on DMG pin.

HVLED807PF 数据表(PDF) 30 Page - STMicroelectronics

HVLED807PF 数据表(HTML) 30 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

数据表下载