UM1811 datasheet(14/52 Pages) STMICROELECTRONICS

14 / 52 page

G3LIB menu

UM1811

14/52

DocID026814 Rev 1

Below this SET command, a list of options or a text box allows providing the value with

which the selected attribute is set.



G3LIB-SWRESET.Request: this command performs a software reset of the G3-PLC

protocol stack (RTE and non-RTE part.).



G3LIB-GET/SET.confirm: these commands are used to get asynchronous confirm

message from the application to the connected device. Note that the “Confirm”

message is sent automatically by the application as described in Section 3.4 on page

12.

4.2

G3LIB IB EX menu

IB-EX stands for the information base explorer. This menu offers the user the ability to

read/modify any attribute of the library information base.

It is made of a white board in which the user can drag and drop the desired attribute from

the list on the left side.

Figure 8. G3LIB information base explorer

More than one attribute may be added in the white board. A generic set/get method is then

available to write/read the attribute.

UM1811 数据表(PDF) 14 Page - STMicroelectronics