93LC66A/B

DS21209A-page 4

Preliminary

© 1997 Microchip Technology Inc.

3.0

FUNCTIONAL DESCRIPTION

Instructions, addresses, and write data are clocked into

the DI pin on the rising edge of the clock (CLK). The DO

pin is normally held in a HIGH-Z state except when

reading data from the device, or when checking the

READY/BUSY status during a programming operation.

The READY/BUSY status can be verified during an

ERASE/WRITE operation by polling the DO pin; DO

low indicates that programming is still in progress, while

DO high indicates the device is ready. The DO will enter

the HIGH-Z state on the falling edge of the CS.

3.1

START Condition

The START bit is detected by the device if CS and DI

are both high with respect to the positive edge of CLK

for the first time.

Before a START condition is detected, CS, CLK, and DI

may change in any combination (except to that of a

START condition), without resulting in any device oper-

ation (ERASE, ERAL, EWDS, EWEN, READ, WRITE,

and WRAL). As soon as CS is high, the device is no

longer in the standby mode.

An instruction following a START condition will only be

executed

if

the

required

amount

of

opcodes,

addresses, and data bits for any particular instruction is

clocked in.

After execution of an instruction (i.e., clock in or out of

the last required address or data bit) CLK and DI

become don't care bits until a new START condition is

detected.

3.2

Data In(DI) Data Out (DO)

It is possible to connect the Data In (DI)and Data Out

(DO)pins together. However, with this configuration, if

A0 is a logic-high level, it is possible for a “bus conflict”

to occur during the “dummy zero” that precedes the

READ operation. Under such a condition the voltage

level seen at Data Out is undefined and will depend

upon the relative impedances of Data Out and the sig-

nal source driving A0. The higher the current sourcing

capability of A0, the higher the voltage at the Data Out

pin.

3.3

Data Protection

During power-up, all programming modes of operation

2.2V. During power-down, the source data protection

circuitry acts to inhibit all programming modes when

Vcc has fallen below 2.2V at nominal conditions.

The ERASE/WRITE Disable (EWDS) and ERASE/

WRITE Enable (EWEN) commands give additional pro-

tection against accidentally programming during nor-

mal operation.

After power-up, the device is automatically in the

EWDS mode. Therefore, an EWEN instruction must be

performed before any ERASE or WRITE instruction can

be executed.

FIGURE 3-1:

SYNCHRONOUS DATA TIMING

CS

CLK

DI

DO

(READ)

DO

(PROGRAM)

STATUS VALID

Note: