Modes of Operation

RESET:

In the RESET mode all the internal registers are reset to the default values (Boost output register 3Fh

(5.0V), all other registers 00h). Reset is entered always if input NRST is LOW or internal Power On Reset

is active.

STANDBY:

The STANDBY mode is entered if the register bit NSTBY is LOW and Reset is not active. This is the low

power consumption mode, when all circuit functions are disabled. Registers can be written in this mode and

the control bits are effective immediately after start up.

STARTUP:

INTERNAL STARTUP SEQUENCE powers up all the needed internal blocks (V

To ensure the correct oscillator initialization, a 10 ms delay is generated by the internal state-machine.

Thermal shutdown (THSD) disables the chip operation and Startup mode is entered until no thermal

shutdown event is present.

BOOST STARTUP: Soft start for boost output is generated in the BOOST STARTUP mode. In this mode the boost output is

raised in PFM mode during the 10 ms delay generated by the state-machine. The Boost startup is entered

from Internal Startup Sequence if EN_BOOST is HIGH or from Normal mode when EN_BOOST is written

HIGH.

NORMAL:

During NORMAL mode the user controls the chip using the Control Registers. The registers can be written

in any sequence and any number of bits can be altered in a register in one write.

20080525

www.national.com

6