9/39

M25P16

Protection Modes

The environments where non-volatile memory de-

vices are used can be very noisy. No SPI device

can operate correctly in the presence of excessive

noise. To help combat this, the M25P16 boasts the

following data protection mechanisms:

■

can provide protection against inadvertant

changes while the power supply is outside the

operating specification.

■

Program, Erase and Write Status Register

instructions are checked that they consist of a

number of clock pulses that is a multiple of

eight, before they are accepted for execution.

■

All instructions that modify data must be

preceded by a Write Enable (WREN)

instruction to set the Write Enable Latch

(WEL) bit . This bit is returned to its reset state

by the following events:

–

Power-up

–

Write Disable (WRDI) instruction

completion

–

Write Status Register (WRSR) instruction

completion

–

Page Program (PP) instruction completion

–

Sector Erase (SE) instruction completion

–

Bulk Erase (BE) instruction completion

■

The Block Protect (BP2, BP1, BP0) bits allow

part of the memory to be configured as read-

only. This is the Software Protected Mode

(SPM).

■

The Write Protect (W) signal allows the Block

Protect (BP2, BP1, BP0) bits and Status

Register Write Disable (SRWD) bit to be

protected. This is the Hardware Protected

Mode (HPM).

■

In addition to the low power consumption

feature, the Deep Power-down mode offers

extra software protection from inadvertant

Write, Program and Erase instructions, as all

instructions are ignored except one particular

instruction (the Release from Deep Power-

down instruction).

Table 2. Protected Area Sizes

Note: 1. The device is ready to accept a Bulk Erase instruction if, and only if, all Block Protect (BP2, BP1, BP0) are 0.

Status Register

Content

Memory Content

BP2

Bit

BP1

Bit

BP0

Bit

Protected Area

Unprotected Area

0

0

0

none

0

0

1

Upper 32nd (Sector 31)

Lower 31/32nds (31 sectors: 0 to 30)

0

1

0

Upper sixteenth (two sectors: 30 and 31)

Lower 15/16ths (30 sectors: 0 to 29)

0

1

1

Upper eighth (four sectors: 28 to 31)

Lower seven-eighths (28 sectors: 0 to 27)

1

0

0

Upper quarter (eight sectors: 24 to 31)

Lower three-quarters (24 sectors: 0 to 23)

1

0

1

Upper half (sixteen sectors: 16 to 31)

Lower half (16 sectors: 0 to 15)

1

1

0

All sectors (32 sectors: 0 to 31)

none

1

1

1

All sectors (32 sectors: 0 to 31)

none